How to Create a Pewter Faux Finish

Save
Pewter has a dull silver surface with black and dark gray undertones.
Pewter has a dull silver surface with black and dark gray undertones. (Image: pewter jewerly box image by nutech21 from Fotolia.com)

Pewter is a rugged, rustic metal with a dull silver finish flecked with black. It can be found in everything from beer mugs to candlesticks. One of the great things about pewter finishes is the matte sheen, which requires no polishing. When preparing to apply faux finishes, choose items that you are reasonably certain you do not want in their current condition, because the process is difficult to reverse. Metal, wood and smooth plastics make ideal surfaces for this finish, which will be applied in two parts.

Things You'll Need

  • Sandpaper or steel wool
  • Plastic sheeting
  • Masking tape
  • Spray primer
  • Flat black spray paint
  • Silver spray paint
  • Clear acrylic finish, matte

Sand or rough up the surface lightly with 220-grit sandpaper or ultra-fine steel wool, so the paint will adhere properly.

Set the item to be finished on a plastic tarp, or mask off around it with plastic and masking tape if it is permanently attached, such as a light fixture might be. Remove screws or similar pieces, as well as glass and other non-paintable surfaces, or cover them with masking tape.

Apply a coat of spray primer to the entire area to be faux-finished. Hold the can 8 to 10 inches from the surface and move it in stroking motions, keeping the can moving, releasing the trigger at the end of each stroke. Allow the primer to dry for 30 minutes.

Spray on a coat of flat black enamel using the same spray technique. Be sure to cover all of the primer so that none of it shows through the black. Allow the black coat to dry until it is completely dry to the touch.

Apply a coat of silver spray enamel. The cheaper paint gives a more convincing matte finish. Avoid paints that are advertised as chrome repair or have very high-gloss finishes; what you need is the right look. Apply the silver sparingly so that some of the black shows through in a few places to give dark gray shadows. Work to prevent runs and drips by spraying in short bursts.

Dust the silver with a few very light strokes of black to give the feeling of the porous surface. Hold the can farther back and work in very short, stationary bursts. This will speckle the silver and add depth to the finish. Don't worry if you go too far; more silver can be added. Once you have the look you are happy with, stop.

Apply a coat of matte clear enamel spray finish over the silver to seal the finish.

References

  • “Decorative Paint and Faux Finishes”: Jeanne Huber; Sunset Books, 2006
  • “Air Brushing and Spray Painting Manual”: Ian Peacock; Argus, 1985
Promoted By Zergnet

Comments

You May Also Like

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!