How to Remove Sanding Marks in Hardwood Floors

Save

Things You'll Need

  • Drum sander
  • 100-grit sand paper
  • Extension cord
  • Broom
  • Vacuum
  • Safety glasses
  • Work gloves

Sanding marks from a floor sander are a great concern when sanding hardwood floors. The weight of the machine makes it extremely easy to leave sanding marks. These marks, also known as chatter marks, can be difficult to remove, especially if they are fairly deep into the wood. Although usually left to the professionals, a skilled homeowner can remove sanding marks in hardwood floors.

Tip

  • Sponsored Tip: A strong maintenance routine is the key to the longevity and durability of your floors. Staying active with a daily maintenance routine is the first line of defense, but daily cleaning alone will not protect your floor's finish forever. A floor's finish will go through normal wear and tear over the years and will need attention. Revive, Restore or Refinish your floors to increase the longevity of your floors and protect your investment. Find a Bona Certified Craftsman to start your hardwood floor renovation.

Instructions

Step 1

Put 100-grit sandpaper in the drum sander. A lot of times the sanding marks in hardwood floors result from sandpaper grit that is too coarse. Finish sanding is key to not having any sanding marks appear when the stain and clear coat are applied.

Step 2

Plug in the drum sander. If needed, use an extension cord to reach the nearest outlet. Lift the floor sander up when you turn it on so that the drum is off the floor. Turn it on and when it comes up to full speed, slowly lower it to the floor. Walk at an even pace and when you reach the end of the room lift the sander up before you try to turn.

Step 3

Continue sanding with the finer grit sandpaper until the entire room is sanded. Lift the drum sander up off the floor when turning it off. Don't set it back down until the drum stops turning completely. If any nails appear, countersink them back into the wood.

Step 4

Hand-sand the edges of the room where the drum sander could not reach. Sweep and vacuum up all loose wood particles. Your hardwood floor should now be ready for stain and clear coat.

Tip

  • Stay away from disc sanders for hardwood floors; they will leave circular swirls in the wood.

    If hand-sanding the edge isn't your cup of tea, edgers are available that can sand right up to the edge of your baseboard.

    If your hardwood floor is thinner than 3/4 of an inch thick, consult a professional before sanding so that you do not sand into the subfloor.

Warning

  • Do not start the sander with the drum contacting the floor, because the sander can gouge out the floor. This could lead to hefty replacement costs.

    Wear work gloves and safety glasses when sanding. Loose wood particles kicked up by the sander could get under the skin or in the eyes.

Related Searches

References

Promoted By Zergnet

Comments

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!