Create an inexpensive wood block candleholder that will certainly be a conversation starter at your next dinner party. You can customize the paint and stain colors as well as the size of candles to fit your style.
Things You'll Need
4-by-4-inch wood post, 16-inch length
- Miter saw
- Electric sander or a sanding block
- 220-grit sandpaper
- Drill with spade bits
- Dropcloth or piece of cardboard
- Painter's tape
- 2 paintbrushes
- Rag or old T-shirt
- Paint and/or stain
- Spray polyurethane
- 6 tapered candles
Step 1: Cut the Post
Using a miter saw, cut the 4-by-4-inch wood post into a 16-inch section. If you use a fence post, you will have enough to make two candleholders.
If you are not comfortable using a saw, simply ask your local hardware store to cut your post to size. Most stores will do this free of charge.
Step 2: Sand the Wood
Lightly sand all four sides and both ends with 220-grit sandpaper until smooth. You can also use a sanding block if you do not have an electric sander.
Step 3: Measure Placement
Measure 2 inches in from each end of your block and make a mark for the outer two candles. Then make a mark for the four other candles spaced approximately 2 1/4 inches apart.
Choose a 3/4-inch spade bit or one that is the same size as the base of the candle you are using.
Step 4: Drill Holes
Using your drill and spade bit, drill the first hole 1 inch into the wood block. This should be deep enough for the candle to stand up straight. Repeat this step for the remaining five holes.
Give the top of the block another quick sanding. Also use your sandpaper to lightly sand the insides of the holes so that they will be smooth when you insert your candles.
Step 5: Tape, Stain and Paint
Using the painter's tape, tape off a design of your choice such as a geometric pattern or stripes. You can use paint or stain or a combination of both. In this case both are used to create a modern, geometric pattern.
Apply the stain to the area with a paintbrush, and wipe off any excess with a rag. Let the stain dry for 24 hours.
Next, tape of the area where you plan to paint. Stuff pieces of an old T-shirt or rag into the holes so the paint will not run down into the holes.
Apply two coats of paint to the wood block, sanding between each coat. Remove the tape before the second coat is completely dry for a crisp edge.
When the paint is completely dry, in approximately four to six hours, spray on a coat of polyurethane to protect your candleholder.
Style and Use Your Candleholder
Insert your candles into the holes and enjoy a beautiful candlelit dinner.