How to Build Your Own Homemade Lightsaber

Save
you too can build your own lightsaber
you too can build your own lightsaber (Image: tool bag and tools 1 image by Warren Millar from Fotolia.com)

The lightsaber is one of the most iconic props from the Star Wars films and no homemade Jedi costume would be complete without one. One of the good things about building your own lightsaber, as opposed to some other parts of a Star Wars costume, is that you can customize the look of your lightsaber to your own personal tastes. That means that other than general look of the piece, the entire design is up to you. And it's a fairly quick and straightforward process.

Things You'll Need

  • PVC piping
  • Small saw
  • Silver screws
  • Buttons
  • Bathroom sink plug
  • Hobby knife
  • Model glue
  • Spray paint
  • Masking tape
  • Plastic tubing

Take your piece of PVC pipe and use the saw to cut it down to the about six inches.

Use the model glue to glue any of the custom pieces (silver screws, square or rectangular buttons, etc.) onto the lightsaber. Be sure to leave room on the hilt so your hands can easily wrap around it.

Glue the edges of a rubber sink plug and insert it into one end of the lightsaber. This will form the bottom end of the weapon. If the sink plug is too big and won't fit, use the hobby knife to cut its edges down to size.

Coat your lightsaber with spray paint of your desired color and wait for it to dry. Place masking tape over any parts of the saber you don't want painted and remove when the paint is dry.

Insert a piece of long plastic tubing (available from most hardware stores) into the open hole at the end of the saber. Make sure the tubing is just big enough to fit snugly in the end of the saber. You can purchase colored tubing or spray paint it the color of your choice. This will form the blade of the lightsaber and can be removed easily if you want to hang it from a belt.

References

Promoted By Zergnet

Comments

You May Also Like

Check It Out

DIY Wood Transfer Christmas Ornaments

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!