How to Make Foot Bracelets

Save
Beads to make a foot bracelet.
Beads to make a foot bracelet. (Image: jewlery beads and charms image by Ralph Petty from Fotolia.com)

Foot bracelets are beaded decorations for feet that wrap around the ankle and loop over one toe. The simplest way to make foot bracelets is with elastic beading cord so that you can stretch them on and off of your foot. Select crystal beads, wood beads, ceramic beads or even plastic beads to make the foot bracelet designs. Smaller seed beads work best for the section that fits around the toe, but larger 4mm-to-8mm beads work well for the center of the bracelet's design.

Things You'll Need

  • Measuring tape
  • Elastic beading cord
  • Scissors
  • 2 alligator clips
  • Size 8 seed beads
  • 4mm beads
  • 1 large 15mm center drilled bead
  • Jeweler’s glue

Loop a measuring tape around your ankle, down around your big or second toe and back up to the metal tip at the beginning of the tape. Note the measurement where the tape touches the beginning of the metal tip. This is the length of the foot bracelet.

Cut a length of elastic beading cord 4 inches longer than the desired length of the foot bracelet. The extra 4 inches will make knotting the cording easier.

Wrap the center of the elastic cording around the toe you measured earlier. Clip the elastic cord at the two points where it clears the top of your toe with alligator clips. Measure the distance between the two clips. Remove one of the clips.

Thread seed beads over the end of the elastic cording closest to the clip that you removed. Thread the seed beads to the alligator clip still attached to the cording. Thread a length of seed beads equal to the measurement for the toe. Remove the remaining alligator clip.

Measure the top of your foot from the end of the toe to the center of the foot. Hold the ends of the elastic beading cord so that they are even. The row of seed beads will be in the center. Add 4mm beads over each end of cording to equal the length between the toe and the center of your foot. Thread the beads to the seed beads. Make sure that the ends of the cording are still even.

Hold the ends of the cording together. Thread the large 15mm center-drilled bead over both ends of the cording. Slide the bead until it touches the 4mm beads.

Separate the cording and continue to thread 4mm beads to within 2 inches from each end of the cording. Tie the ends of the cording together in a triple overhand knot. Thread the ends of the cording back through the 4mm beads. Cover the knot with jeweler’s glue. Let the glue dry.

References

Promoted By Zergnet

Comments

You May Also Like

Check It Out

DIY Wood Transfer Christmas Ornaments

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!