How to Increase Vanity Height

Save
You can raise your bathroom vanity with wooden blocks.
You can raise your bathroom vanity with wooden blocks. (Image: Comstock/Comstock/Getty Images)

Bathroom vanities come in a variety of makes and models, but many of them have one feature in common -- height. The B4UBuild website states that the majority of bathroom vanities have a standing height of 29 inches, with marble vanity tops adding about another inch, meaning that most vanities are about the same height as a kitchen table. For a number of individuals, preference or height make the standard size too short for everyday use. These people may look for a way to increase the height of their vanity.

Things You'll Need

  • Towel
  • Prybar
  • 2-by-4 or 2-by-6 wood blocks
  • Electric drill
  • Screws
  • Decorative material

Turn off the water source and disconnect piping if the vanity contains a sink.

Lay a towel on the floor around the vanity.

Pry the vanity from the floor using a prybar, taking care to place the prybar on the towel to avoid damaging the floor.

Screw the 2-by-4 or 2-by-6 wood blocks securely into the footprint of the vanity using a drill. Block size is dependent on the desired final height of the vanity. Don't place the blocks against the outer edge of the vanity's footprint or they may stick out when the vanity is replaced.

Place the vanity on top of the blocks. Two or more people may be required to lift the vanity.

Screw the vanity securely into the blocks.

Install a decorative covering to hide the wood blocks. B4UBuild recommends matching the cabinet materials or wooden baseboard material or using ceramic tile to match the bath flooring, which gives a built-in appearance to the vanity.

Reconnect any pipes and turn the water back on if necessary.

Tips & Warnings

  • Plumbing or electrical work should be performed by professionals.

References

Promoted By Zergnet

Comments

You May Also Like

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!