How to Make Cardboard Tombstones

Start off by figuring out how big you want your tombstones to be. This one is 27 inches by 20 inches. Use your desired measurements to draw a tombstone shape on the cardboard. If you'd like to create a curve at the top, you can use a large bowl as an outline. Be sure to leave 3 inches of extra space at the bottom of the tombstone to fold under it later. Cut out the tombstone shape and then use it as a pattern to trace an identical tombstone on another piece of cardboard. Cut out the second tombstone -- you will use both to create a 3D effect.

Cut two pieces of cardboard at 20 inches by 3 inches. Cut down the center of each piece by 1 1/2 inches. Now take these pieces and slide the cut parts together, inserting them into each other to make an "X" or a cross. This piece will go between the two tombstone pieces you cut in the previous step to give the tombstone support and help it not fold into itself.

Stand up the two tombstone pieces side by side with the extra 3 inches folding underneath each another to create the bottom of the tombstone. Tape the bottom pieces together with packing tape.

Create the side pieces of the tombstone by cutting two strips of cardboard measuring from the bottom of the tombstone pieces to just before the curve starts at the top by 3 inches wide. Tape the X-shaped support piece of the tombstone to one of the interior sides of the two tombstone pieces. Now place the side pieces in the gap between the two tombstone pieces to create a complete 3D tombstone and tape them to both of the tombstone pieces.

Fill two plastic sandwich bags with sand and place them on the inside of the tombstone. Alternatively, you can use bricks. This will help keep the tombstone standing tall when it's outside. Now, cut out one strip of cardboard measuring 3 inches by 24 inches. This will serve as the curved top of the tombstone. Tape this in place at the top of the tombstone, in between the two tombstone pieces.

Use newspaper and decoupage glue to create a paper mache over the top of the tombstone and give it that final rounded effect. Apply about three layers of newspaper to give it a solid feel. Let it dry completely, which may take several hours.

Use spray paint to paint the tombstone, and make sure you are spraying in a well-ventilated area or outside. Either a gray or dark gray color works well for the first layer. Next, spray a rustic umber textured spray paint for the second layer. This will give it a more realistic concrete look. You could also sponge some flat black paint around the edges of the tombstone for a weathered effect.

Use 3-inch stencils to outline the letters you will use for the names/words on the tombstone. Cut out the letters with scissors and spray paint them with a flat black paint.

Use the glue gun to glue the letters onto the tombstone. Lay the tombstone down flat and place the letters where you want them before gluing them down.

Create any finishing touches on your tombstone, such as a spiderweb effect (drawing it on with hot glue). You can also decorate your tombstone with some cotton spider webs and some fake spiders, too. You could even go a step further by placing a fake rose in front of the tombstone or placing a brown towel in front of the tombstone with bunched up newspaper underneath to give it a "freshly dug-up" feel.