How to Weave a Chair

Save

Spruce up an old chair with a cotton, leather or nylon woven seat to add a designer look to any home. While making a woven chair on your own may appear challenging, with a few supplies the project can be relatively easy to take on even if you have no furniture-making experience. Creating a woven chair requires special materials, such as upholstery weaving strips, to make the chair safe for sitting.

Things You'll Need

  • Wooden chair or stool
  • Cotton, nylon or leather weaving strips (2 inches wide)
  • Upholstery nails
  • Staple gun
  • Staples
  • Rubber mallet
  • Find an old chair that does not have the seat, or carefully remove the seat of a chair with a hammer. Keep the seat frame intact.

  • Purchase 2-inch wide upholstery webbing at a craft store in your choice of leather, cotton or nylon.

  • Cut the upholstery webbing into strips two inches longer than the length of the chair seat. Cut enough strips to cover the length of the seat. You may have a few leftover strips or cut the strips one-by-one as you weave for an exact amount.

  • Cut strips of upholstery webbing two inches wider than the width of the chair seat. Cut enough strips to cover the width of the seat. You may have a few leftover strips or cut the strips one-by-one as you weave for an exact amount.

  • Start laying the strips on the width of the chair. Begin the first strip one inch from the front of the seat frame. Lay the strip across the width of the chair, with each end hanging slightly over the sides. Fold the ends under one-half inch and tightly staple each side to the sides of the chair frame. Repeat each strip until the width of the seat is covered.

  • Cover the staples with decorative upholstery nails by carefully banging the nails in with a rubber mallet. Use as many nails as needed to hide the staples. Keep a uniform number of nails on each strap.

  • Begin to lay strips across the length of the chair once its width is covered. Start at one corner of the front of the seat and staple the strip to the front frame, with the raw end folded under 1/2 inch. Work your way backward with the strip, weaving in an under-and-over repetition until you reach the back of the seat. Staple the strip on the back of the chair frame with the raw end folded under 1/2 inch. Repeat for each strip until the length of the chair is covered.

  • Cover the staples with decorative upholstery nails by carefully banging the nails in with a rubber mallet. Use as many nails as needed to hide the staples. Keep a uniform number of nails on each strap.

  • Test the center of the chair by pushing down hard with your hands to confirm the weaving is sturdy.

Tips & Warnings

  • Ensure the weaving is firmly in place before sitting.

Related Searches

References

  • Photo Credit Jupiterimages/Photos.com/Getty Images
Promoted By Zergnet

Comments

You May Also Like

  • How to Restring Chair Seats

    Restringing or webbing a chair seat will bring new life to your furniture, whether you're looking to revamp a family heirloom or...

  • How to Weave Lawn Chairs

    Lawn chairs take quite a beating. In the case of nylon webbed chairs with aluminum frames, it is normally the nylon that...

  • How to Weave Chair Bottoms

    To make your own chair bottom, select a durable material that is recommended for weaving, such as cane, which comes from the...

  • Nylon Chair Tips

    Nylon is a synthetic fabric that cleans easily and provides a soft feel for both garments and furniture. Outdoor sling chairs or...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!