Corrugated PVC sheeting is an economical roofing material that is available in many different colors or can be transparent. With different thicknesses and strengths it is suitable for a wide range of uses from garage roofs to conservatories. Requiring little maintenance and, being relatively easy to install, a correctly fitted PVC corrugated roof should last for many years before needing replacement.
Things You'll Need
- PVC Corrugated sheeting
- Ridge pieces
- Tape measure
- 3/8-inch drill bit
- Hacksaw with plastic cutting blade
- 5/16-inch roofing nails
Measure the length and width of the roof by using a tape measure. Multiply the two measurements together to get the total area of the roof. When purchasing the PVC corrugated sheets remember that the sheets need to overhang the verge of the roof by 2 inches. Also, each sheet overlaps the next as it is laid horizontally and by 2 inches vertically.
Measure the location of the purlins - the horizontal rafters - from the bottom edge of the roof to the roof ridge. Draw a line across one PVC sheet to mark the location of the purlins. Measure from the bottom of the sheet and add 2 inches to allow for the overhang and overlapping.
Lay the marked sheet upside down on soft ground. Drill holes, using a 3/8-inch drill bit suitable for plastic, along the bottom purlin mark in the lowest part of each corrugation and in each corrugation for the top purlin. Drill holes in every fourth corrugation for purlins in between the top and bottom. Use this sheet as a template to drill holes in the remaining sheets.
Lay the first sheet on the roof starting at the bottom corner furthest from the direction of the prevailing winds. Remember to set the PVC sheet so that it overhangs the bottom and side ridges by 2 inches. Hammer in 5/16-inch roofing nails through the drilled holes, into the purlins. Do not allow the corrugation to become compressed by the nails.
Lay the next sheet in the row overlapping the first and nail it in place. Overlap each sheet by a regular amount of corrugations so that you do not have to cut any sheets to size for the first row.
Cut the first sheet of the second row in half using a hacksaw with a blade suitable for plastic. Put one half aside to be used for the start of the fourth row. Lay the cut sheet with the manufactured, finished edge overhanging the roof verge, the rough cut edge will be hidden by the next overlapping sheet. Hammer the nails in place and continue laying the sheets, alternating the first sheet of each row with a full sheet then a half sheet.
Nail the ridge pieces along along the top ridge of the roof starting at the furthest edge from the prevailing winds. Fit ridge pieces to the verges of the roof nailing them to the side barge boards.
How to Fix PVC Water Pipes
When your plumbing springs a leak, you don't always need to call a plumber. Especially if you have PVC water pipes, the...
How to Install Suntuf Roofing
Suntuf Roofing is an easy to install roofing, privacy wall or wind break that can be used to improve outdoor areas. Tinted...
Instructions for PVC Roofing Installation
Roofing materials come in different levels of quality, longevity and durability. One of the roofing materials that offer a good price-to-quality ratio...
How to Work With PVC Sheet Material
PVC is a versatile thermoplastic used in a variety of industries for a wide number of purposes. It can be made flexible...
How to Install Metal Roof Purlins
Metal roof purlins are installed horizontally under metal roofs. They are installed on top of the roof rafters with a felt underlayment...
How to Attach Corrugated Fiberglass Roof Panels
Corrugated fiberglass panels are made of synthetically produced glass fibers, designed to provide a waterproof seal along with a tough, durable structure...
How to Install Corrugated Polycarbonate Sheets
Corrugated polycarbonate sheeting keeps outside weather from coming in a building while still allowing natural light to flow into the building. The...