Installing a trapdoor through a plywood subfloor is a simple procedure requiring less than an hour in most cases. Framing needs to be added underneath to support the door; then it is just a matter of cutting the trap in the plywood and adding hinges to make the door easily accessible. Remove any carpet from the area before starting installation.
Things You'll Need
- Electronic stud finder
- Tape measure
- Circular saw
- 2-by-4 lumber
- Screw bit
- 3-inch treated deck screws
- Paddle bit
Choose a location for your trapdoor. Use an electronic stud finder to locate the floor joists on either side of the door. Depress the buttons on both sides of the device and drag it along the floor, marking each spot where the finder beeps and lights up. Do this in a line 6 inches on either side of the trapdoor, about 36 inches long. Connect the marks to outline where the joists are located.
Draw a 24-inch square for the trapdoor on your floor, with two of its edges centered on joists, which are spaced 24 inches center to center. Cut the trapdoor out with a circular saw with the depth set to the thickness of the floor, typically 3/4 inch. Lift the plywood square from the opening.
Cut two pieces of 2-by-4 to fit between the two joists supporting the edges of the trapdoor. Screw them between the joists with 3-inch treated deck screws so that the center of the top edge of each piece is aligned with the edge of the cut opening, providing a 3/4-inch lip around the opening on all sides. Lay the plywood on its top, with one edge aligned with one edge of the hole. Screw two 1-inch utility hinges to the edge of the trapdoor and the edge of the floor.
Prop the trapdoor up and use a 1-inch paddle bit to bore a hole, centered, 2 inches from the edge opposite the hinges. Close the trapdoor back into its original position.
- "The Complete Guide to Building Your Own Tree House"; Robert Miskimon; 2010
- Photo Credit construction image by Greg Pickens from Fotolia.com
How to Install a Sliding Glass Patio Door
A sliding glass door is a great addition to let in more light and air or act as an eye-catching access to...
How to Install a Shower Drain Trap
Shower drain traps are designed to work just like any other drain trap: water flows to a low point in the pipe...
How to Booby Trap a Door
Booby traps are frequently used in adventure movies like the "Indiana Jones" series and "Goonies". Booby trapping a door is a prank...
How to Build Trap Doors in Treehouse Decks
Every kid needs a place to escape the adult world from time to time. Treehouses have supplied this escape for children for...
How to Install a Partial or Full Floor in the Attic for Storage
Covering part or all of the ceiling joists in the attic is a cheap way to make use of wasted space. Installing...
How to Install MIFAB Trap Primer
The basic function of trap seal primers is to furnish the "P" trap, or deep seal of the floor drain, with water....
Installing Shower Doors
Finish installing a shower by putting on shower doors. Learn how to add a new bathroom to a home, including tips on...