How do I Recover Seating for Aluminum Chairs?

Save

Your patio furniture suffers through harsh climate changes every season. Sooner or later this exposure to heat and rain will take its toll on even the best of pieces. Rather than tossing the worn-out chairs, you can replace broken straps and mesh to bring your patio furniture back to life. Finish your chair's recovery by touching up the paint, and your patio furniture will be ready to enjoy for years to come.

Things You'll Need

  • Scissors
  • Drill
  • Gloves
  • Hot water
  • Tongs
  • Cloth measuring tape
  • Detergent
  • Utility knife
  • Wire cutter
  • Rubber mallet

Repairing Vinyl Straps

  • Measure the width of the existing straps and buy replacement strapping. Cut existing damaged strapping and remove the strap and steel tabs from the chair frame. Set the tabs aside. Discard the damaged straps. Clean the chair with a mild detergent and water.

  • Measure the distance from one rail to the other, using a cloth measuring tape. Wrap the tape around the chair rails one-and-a-half times, in the same manner as the straps were attached to the frame. Multiply that measurement by .85 and add 1 inch. For example, if your hole-to-hole measurement is 36 inches, multiply that by .85 to get 30.6, then add 1 inch to get a measurement of 31.6.

  • Cut a strip of vinyl to measurement from Step 2. Drill holes in each end about 1/2 inch from the end and trim the corners diagonally toward the hole.

  • Soak the strap in hot water for about five minutes. Attach it to one end of the chair by pushing the steel tab through the end of the vinyl and through the hole in the back of the chair. Wrap the strap completely around the frame, covering the tab.

  • Pull the strap tightly over the chair to the opposite side. Stretch it and wrap it around the frame one-and-a-half times.

  • Push the steel tab into the hole of the vinyl strap and into the hole in the chair. Slide the loop over the tab and release the strap. The strap will contract as it cools.

  • Repeat the process for any remaining damaged straps.

Repairing Mesh Sling Chairs

  • Measure the chair mesh by using a cloth measuring tape. Measure from side rail to side rail at the widest part. Find the length by following the curve of the chair with the measuring tape.

  • Cut the old sling down the center with a utility knife. Remove the end caps off each side rail and slide the halves of the sling out from the tracks on each side.

  • Loosen the bolts that attach the rails to the frame and pop out the spreader bar---the thin bar that runs across the back of the chair from side to side.

  • Remove one rail entirely. Holding the replacement sling with its hem side toward the back of the chair, slide the nylon rod onto the track of the rail that is still attached to the frame.

  • Slide the detached rail over the rod on the opposite side and bolt the rail back onto the frame. Tighten the bolts on both rails to make the sling taut.

  • Reinsert the spreader bar by spreading the rails apart and bending the bar to pop it back into place. If necessary, tap it with a rubber mallet to restore its shape.

  • Trim the rods with a wire cutter, then push the end caps back on the rails.

References

  • Photo Credit Inti St. Clair/Stockbyte/Getty Images
Promoted By Zergnet

Comments

You May Also Like

  • How to Restore Weathered Metal Furniture

    Some types of metal furniture look best painted, while others are better left all natural. For lightweight aluminum furniture, such as the...

  • How to Repair Chair Straps and Webbing

    Spending a little time each fall performing some maintenance and repair--along with a good cleaning--will keep your chairs looking good for years...

  • How to Redo My Mesh Patio Chairs

    Metal patio chairs often have mesh webbing strung tightly across the seat and back areas to provide comfortable outdoor seating. With regular...

  • How to Reupholster Outdoor Furniture

    Taking the time to reupholster outdoor furniture instead of replacing it will save you money and give your patio a fresh, updated...

  • How to Replace Lawn Chair Mesh

    Lawn chairs are indispensable items during the summer months. People use them for cookouts, ball games, picnics and many other social events....

  • How to Make Leather Cushions

    A simple leather cushion can add a lot of character to your couch or chairs. Larger leather cushions can also become seats...

  • How to Recover Patio Chairs

    Exposure to the elements eventually wears on patio furniture, requiring that the patio chair or cushions be recovered. Recovering patio chairs makes...

  • How to Repair Sling Patio Chairs

    Patio chairs fitted with a mesh sling seat are designed to be durable and withstand the elements. Over time, however, the mesh...

  • How to Repair Patio Chairs

    Patio chairs are built with materials meant to survive through extreme weather conditions, including harsh UV rays, freezing cold, temperature fluctuations and...

  • How Do I Replace Leather on a Wassily Chair?

    The Wassily chair was invented in the 1920s by Marcel Breuer, a renowned architect. This iconic lounge chair was named for the...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!