Copper gutters are expensive. However, when properly installed, their initial cost is offset significantly by their durability and lack of maintenance. Unlike coated steel, they do not require periodic painting. Unlike vinyl or aluminum, copper will last for the life of the average homeowner. To ensure watertight joints, apply solder to join gutter sections.
Things You'll Need
- 200-grit sandpaper
- Clean rag
- Acid flux
- Soldering iron or torch with soldering tip
Lightly sand the ends of the gutters you will be joining. Sand a 1 1/2-inch strip on the bottom side of the upstream gutter. Sand a 1 1/2-inch strip on the top side of the downstream gutter.
Remove sanding dust from both surfaces with a clean cloth. Apply acid flux to both sanded surfaces and press them together. The exposed edge of the seam should now be facing the downstream end of the gutter. Facing the butt-end of the seam downstream allows for a smoother water flow and reduces the risk of leaks.
Heat the soldering iron. The tip should be hot enough to melt solder before you apply it to the copper.
Press the tip of the soldering iron against the surface of the upstream gutter 1 inch above the seam.
Unroll a small amount of solder. Press the end of the solder lightly against the lip of the seam. When the solder melts, it will be wicked between the layers of copper. Move the solder and iron slowly along the seam until the entire seam has been covered.
Tips & Warnings
- Some manufacturers fabricate lock joints on the end of each section of gutter. These will not require an overlap or sanding before solder is applied.
- Do not use rivets with ferrous materials to join copper gutters. These will rust out over time. If you wish to rivet joints before soldering, use only brass or copper rivets. If you can pick a rivet up with a magnet, don't use it on your gutters.
- Do not use an open-flame torch when soldering gutters on the side of a roof. An open flame could easily cause combustible material behind the fascia to ignite.
- Wash your hands thoroughly after using solder and flux. Do not eat, smoke or allow any hand-to-mouth contact while soldering.
- Photo Credit ornate roof detail image by Warren Millar from Fotolia.com
- Sheet Metal Soldering Tools
How to Solder Copper Sheet Metal
Soldering copper sheet metal is a fundamental part of applying a copper roof to your home. The solder seals the connections between...
How to Repair Damaged Copper Gutters
Copper gutters carry water away from the edge of a roof. Water runs down the roof, into the gutter then the downspout....
Techniques for Soldering Gutters
Exterior gutters made of aluminum, steel, or copper often require soldering to hermetically join the individual sections together. Because of hot/cold temperature...
How to Repair a Leaky Gutter
Use SeamerMate on home gutter seams to repair leaky gutters. Fix leaky gutters with tips from a heating, ventilation and air conditioning...