How to Rescreen a Wooden Screen Door

Save

The screen in a wooden screen door can be pushed out over time from use. It can also rip from sharp objects and need to be replaced. Holes and loose edges allow bugs, such as flies and mosquitoes, to fly into the house and annoy people and potentially transmit disease. You can rescreen a wooden screen door in less time and for a lot less money than hiring a contractor to do this easy home maintenance project.

Things You'll Need

  • Screwdriver
  • Screen
  • Tape measure
  • Screen spline
  • Spline roller
  • Utility knife
  • Open the wooden screen door and locate the hinges. Use a screwdriver to remove the door from the hinges. Remove the door from the bottom hinge first.

  • Place the wooden screen door on a stable work surface with the side of the screen with the gasket facing up.

  • Use a small screwdriver to pry the end of the spline, which looks like a narrow rubber gasket, out of the groove. Gently pull the entire spline out of the groove and pull off the old screen.

  • Roll out the new screen on top of the opening. Trim the screen but allow 3 inches of excess around the perimeter of the opening. Use a tape measure if needed to determine this measurement.

  • Position the new screen spline on top of the screen over a corner. Press the screen spline into the groove with a small screwdriver which will press the screen into the groove behind the spline.

  • Hold the screen straight and press the screen spline into the screen with a spline roller. The roller will apply the appropriate pressure while pressing the spline into the groove without stretching the spline. Continue rolling the spline until you reach the corner.

  • Position the screen so the mesh is straight and use a small screwdriver to press the spline into the groove after the corner. Keep the spline slightly tight to prevent the spline from buckling. Repeat for each corner.

  • Use the roller to press the spline and screen into the groove on the wooden screen door until the screen is secured with the spline on the entire frame.

  • Cut off excess spline with a utility knife.

  • Hold the utility knife on an angle on the outside of the spline and trim the excess screen from the wooden screen door frame.

  • Move the door back to the door frame and reattach to the hinges.

Tips & Warnings

  • Clean or paint the wooden screen door if needed while it is off the hinges.

Related Searches

References

  • Photo Credit home sweet home image by David Dorner from Fotolia.com
Promoted By Zergnet

Comments

You May Also Like

  • How to Stain a Wood Door

    Staining a wood door gives the wood a bit of color, shows off the grain and helps to enhance the appearance of...

  • How to Install a Wooden Screen Door

    A simple wooden screen door is a nice addition to any home. It allows fresh air to circulate into your home during...

  • How to Re-Screen Windows & Doors

    Screen doors are common in many American homes, but how a screen is held in place on a screen door or window...

  • How to Rescreen Patios

    Screened patios are only as useful as the screens themselves. Bugs can make it miserable to spend time on your patio. If...

  • How to Rescreen a Sliding Door

    A sliding door with a screen is useful for keeping bugs out of your home while allowing fresh air into the house....

  • How to Paint a Wooden Screen Door

    Although most wooden screen doors are manufactured using pressure-treated lumber, you still can paint the wood to add to the longevity of...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!