How to Measure & Cut Molding

Save

Wall molding is a necessity in any home. Molding finishes the raw edges of flooring, doors, windows and even the ceiling. It also protects walls from becoming damaged, and creates a finished look in you home. The key to properly installed molding is to get the right measurements and cuts on the molding. Improperly measured and cut molding will leave large gaps when installed. Learning how to cut molding will help you avoid this mistake.

Things You'll Need

  • Measuring tape
  • Molding
  • Pencil
  • Miter saw
  • Nail gun
  • Measure the walls in your room with a measuring tape to determine how much molding you will need to purchase. Add approximately one foot to each wall measurement to account for mistakes during cutting.

  • Measure the walls again and mark the measurements onto the molding with a measuring tape and a pencil. For each mitered end on the molding, add the width of the molding to the length of the molding. This will give you the right amount of molding for the cuts you need to make.

  • Adjust the miter saw so it is set to a 45 degree angle. Place the molding onto the miter saw with the back of the molding face down on the saw table.

  • Cut the molding at a 45 degree angle. If the molding needs to be connected in the middle of the wall, splice the two connecting ends. Splice the molding by cutting each of the ends on the molding on a parallel 45 degree angle. Once cut, the ends should slide together easily. If you are joining two pieces of molding together for a corner, you will need to cut the 45 degree angles in opposite directions.

  • Nail the molding onto the wall with a nail gun.

Related Searches

  • Photo Credit ceiling window image by Tammy Mobley from Fotolia.com
Promoted By Zergnet

Comments

You May Also Like

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!