How to Hang Decorative Ledges on the Wall

Save

Decorative ledges and hanging wall shelves allow you to add decorative touches to your normally bland walls. It is imperative to install the hanging wall shelf level, as the attention of the visitors to your home will be directed to the shelf and its contents. Make sure you have a level that is true and a pencil that is sharp; even a slight deviation off level will easily be noticed. Installing a wall shelf is a moderately easy task.

Things You'll Need

  • Ladder
  • Tape measure
  • Pencil
  • Stud finder
  • 4-foot level
  • Drill
  • No. 2 screw tip
  • 2 1/2-inch wood screws
  • Hollow wall anchors
  • Phillips screwdriver
  • Determine the height and location of the wall shelf. Measure from the floor and place a mark on the wall with the pencil.

  • Measure from the top of the shelf to the centerline of the mounting bracket located on the back of the shelf. Place a pencil mark below the height mark for the location of the mounting screw. Use the stud finder to determine if there is a stud located behind the mark. Secure the screw accordingly. If a stud is present, drive a wood screw through the drywall and into the stud. Use a hollow wall anchor to secure the screw to the wall if no stud is present. Follow the manufacturer's installation instructions for the hollow wall anchor. With either method of securing the screw, leave the screw head 3/16-inch away from the surface of the wall.

  • Align the slotted hole on the decorative wall shelf's mounting bracket with the screw secured to the wall. Lay the shelf against the wall. Slide the shelf down until the screw locks into the mounting bracket.

  • Orient the shelf so the top edge is parallel to the floor. Set the 4-foot level on top of the shelf. Adjust the wall shelf until it is level. Place a pencil mark at the top edge of the shelf. Set aside the 4-foot level. Remove the wall shelf and set it aside. Measure down from the top mark of the shelf. Place a mark for the location of the second mounting screw. Use the stud finder to see if a stud is located behind the mark. Insert the second screw into the drywall. Leave the screw head 3/16-inch away from the surface of the drywall.

  • Re-align the shelf with the screws located in the wall. Slide the shelf onto the mounting screws. If there is a gap where the shelf meets the wall, remove the shelf. Tighten the screws with the Phillips screwdriver. Re-hang the shelf. Repeat the process of tightening the screw till the gap against the wall is closed.

References

Promoted By Zergnet

Comments

You May Also Like

  • How to Make a Picture Ledge

    A picture ledge is a wonderful way to keep a rotating display of artwork or family pictures in your home. Because the...

  • How to Build a House on a Ledge

    Differences in geography determine the methods used in building a house on a ledge. The type of rock and exact formation of...

  • How to Hang a Shelf

    Adding storage or display space in your home can be a snap. Here's how to mount a simple wooden shelf and two...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!