How to Replace Wall Studs in a Mobile Home

Save

Mobile home wall studs become damaged or warped over time causing lumps in the wall covering. If the wall bows out too much, beyond what you can stand, you must replace the wall studs in a safe and effective manner. The amount of time necessary for the replacement of wall studs will depend on the size of the job; however, it is reasonable to expect to spend 1 to 2 hours on this project. Replacing mobile home wall studs is not a difficult task, and with due diligence, the average homeowner can complete the job with limited stress.

Things You'll Need

  • Circular saw
  • Tape measure
  • Carpenter's square/combination square
  • Reciprocating saw
  • 3-inch wood screws
  • Screw gun
  • Carpenters hand level
  • Flat bar
  • Hammer
  • Remove any wall covering such as paneling or drywall. If you are removing paneling, use a flat bar to gently work the paneling loose at the joints.

  • Cut the wall studs in half using the reciprocating saw. Once you have the studs cut, gently work the two halves back and forth to remove them from the wall.

  • Remove any protruding nails by cutting them with the reciprocating saw. The nails that attached the studs to the top and bottom plates should remain in the wood. It would be impossible to pull them out, unless you remove the entire wall.

  • Cut the studs to the right length. Measure from the top plate down to the bottom plate. Make sure the top plate isn't sagging; if it is, leave about a 1/4-inch extra on the cut.

  • Replace the wall stud by tapping the new ones into place. Place the top on its mark and gently tap the bottom over to correct mark. Check and make sure the wall stud is plumb using the hand level. Toenail two wood screws at the top and two at the bottom.

Tips & Warnings

  • Be careful when using power tools. Always wear eye protection.

Related Searches

References

Promoted By Zergnet

Comments

You May Also Like

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!