How To Lay Carpet?


The process of laying carpet can be rough on your back and knees, but for the most part is a doable do-it-yourself project. Laying carpet involves renting some tools from your local home improvement store. You can find the carpet and padding at your local carpet shop. Laying carpet can be done with one person, but two makes things easier. Carpet can get heavy depending on the size of the room your refinishing.

Things You'll Need

  • Broom
  • Hammer
  • 1 1/2-inch nails
  • Tack strip
  • Razor knife
  • Padding
  • Carpet
  • Carpet stretcher
  • Knee kicker
  • Seam iron
  • Seam tape
  • Duct tape
  • Door edge strip
  • Prepare the floor by sweeping up any dust or debris. Walk the entire floor; if there are any creaks add 1 ½-inch nails until all creaks are gone.

  • Use your hammer to lay the tack strip ½ inch from the wall around the entire room except for the doorways. Butt the corners tightly together. Face the teeth so they are curving towards the walls.

  • Lay the padding so it overlaps the tack strip, but do not overlap the padding with itself. Use your razor knife to trim the padding, so it's tight up against the inside of the tack strip. Tape the seams with duct tape.

  • Measure the room, and add 3 inches on all sides. Mark the back of the carpet with your measurements. Cut the carpet and place it on the floor. If the room is big and needs a seam, place both pieces on top of each other and cut through them with one cut ensuring they will match up perfectly. Place both sides of the carpet evenly on the seam tape, and heat it with the iron. Let it dry.

  • Using your knee kicker, which is an 18-inch tool with teeth on one end and a pad on the other, stretch the carpet onto the tack strip only on one side of the room. Place the back of the carpet stretcher against the wall you started the carpet on. Place the tooth end 6 inches from the opposite wall, and stretch the carpet. Repeat the same process on all sides until the entire carpet is attached to the tack strip.

  • Use a razor knife to trim the excess carpet tight up against the wall. Trim the carpet in the doorways so the seam is centered under the door. Place the door edge strip on the seam. Cut out holes over any vents, and replace the vents.

Related Searches


  • Photo Credit juhansonin/
Promoted By Zergnet


You May Also Like

  • How to Install Used Carpet

    Many homeowners today are moving away from tile and carpet type flooring to hardwood floors. This is why you can find used...

  • How Install Loose-Lay Carpet

    Loose-lay carpet is also called "loose laid" carpet and is installed without carpet tack strips along the edges. The carpeting itself is...

  • How to Lay Carpet Without a Stretcher

    Although some people prefer to leave laying carpet to the professionals, it is a project well within the reach of a do-it-yourselfer....

  • How to Lay Carpet

    To lay carpet like a pro, you need a tamper to hold the carpet down, a knee kicker to kick the carpet...

  • Which Way to Lay Carpet Padding?

    Laying carpet is a big, expensive job, and one crucial part of it that often isn't considered carefully enough is laying the...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

Is DIY in your DNA? Become part of our maker community.
Submit Your Work!