How to Install the Bearing on a Lazy Susan Turntable

Save

A lazy Susan makes for a fun way to share food between friends and family around the dinner table. Installing a lazy Susan isn't a particularly momentous task, and installing the bearing that the serving plate spins on is the hardest part of the process. This project should be perfect for anyone that cares for a little bit of measuring and drilling, and shouldn't take more than a half hour of careful, precise work.

Things You'll Need

  • Round 1 inch thick woodblock
  • Lazy Susan bearing
  • Drill
  • 4 wood screws
  • Ruler
  • Screwdriver
  • Turn the round woodblock bottom side up and place the the metal bearing so it is aligned in the center. Use a ruler to measure the distance of each side of the square bearing to the rim of the woodblock. If the distance from each of the four sides of the bearing to the edge of the circular woodblock are equal, then it is centered.

  • Drill guide holes approximately as deep as your screws are long in the four holes of the bearing. Drill the holes working across the bearing (top right corner first, bottom left corner second, top left corner third, bottom right corner, for example) to ensure that bearing stays in place.

  • Screw in the wood screws using your screwdriver. Tighten them after all four are in place to ensure a tight fit.

Tips & Warnings

  • Cover the bottom of the bearing with sticky rubber grips to ensure that the lazy Susan doesn't slip on your table surface.

Related Searches

References

  • Photo Credit Jupiterimages/Photos.com/Getty Images
Promoted By Zergnet

Comments

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!