How do I Install Two Satellite Receivers on One Satellite Dish?
Hook up two satellite receivers to your satellite dish to enjoy your satellite TV service on two different TVs. As long as you have a satellite dish with a dual Low-Noise Block down-converter or multiple LNB, the installation will only take a couple of minutes. Use a multi-switch to split the signal from the satellite dish to allow for multiple connections. Multi-switches are powered by the signal sent through the dish's cabling so you will not have to worry about placing the switch near a power outlet.
Other People Are Reading
Instructions
-
-
1
Run the coaxial cable from the LNB on the satellite dish to the "Satellite IN" jack on the multi-switch.
-
2
Connect one side of a coaxial cable to the "LNB IN" port on the back panel of the first satellite receiver. Fasten the other side of the coaxial cable to a "To Receiver" jack on the side of the multi-switch.
-
-
3
Connect one side of another coaxial cable to the "LNB IN" port on the back panel of the second satellite receiver, and fasten the opposite end to an open "To Receiver" jack on the side of the multi-switch.
-
1
