How to Service an Evinrude Power Tilt

Save

Servicing an Evinrude power tilt, making sure the hydraulic fluid levels are where they should be, involves more than just looking at the fluid level and adding fluid if needed. It also means operating the system throughout its full range of motion to ensure that any air trapped in the fluid is moved to the hydraulic reservoir. Once at the open hydraulic reservoir, the air -- in the form of bubbles -- is released to the atmosphere. When the system is burped and the reservoir filled with fluid, the system is in good working order.

Things You'll Need

  • Hydraulic oil
  • Locate the hydraulic reservoir for the power tilt system. Remove the cap from the reservoir -- the fluid in the reservoir should come all the way to the bottom of the filler neck. Leave the cap off the reservoir until the service process is complete.

  • Raise the motor, using the power trim switch located on or adjacent to the throttle handle, to its highest position. Add fluid to the hydraulic reservoir if necessary.

  • Lower the motor to its lowest extent and check the level of the fluid in the reservoir. If the fluid is not even with the bottom of the reservoir's filler neck, add fluid until it is. Raise the motor to its full height once more, using the power trim switch.

  • Check the fluid level in the hydraulic reservoir, adding fluid if necessary. Repeat the process five or more times. If, after multiple repetitions, the fluid level does not remain even with the bottom of the reservoir's filler neck, inspect the area around the reservoir for evidence of leakage, including puddles of hydraulic oil. Pay close attention to the points where hydraulic lines connect to the reservoir.

  • Follow the hydraulic lines, inspecting them for leakage, to the hydraulic pistons (also called rams) that move the motor. Look for hydraulic oil on each end of the ram and around the point where the rod slides into the barrel of the ram, on the deck and on neighboring equipment. Replace hydraulic lines as necessary; rams and reservoirs require professional service.

Tips & Warnings

  • Always return your motor to the "down" position once you have serviced the power tilt system. If there's a problem and the motor is stuck in the "up" position, locate the release knob, located just below the hydraulic ram. Ensure the knob is turned all the way to the left to release pressure on the power tilt system; gravity will return the motor to its "down" position.
  • If you have a leak in a ram, do not attempt to remove the ram yourself.

References

  • "Evinrude Repair Manual -- 2.5 to 250 HP Models, 2002-2007"; Seloc Marine; 2007
Promoted By Zergnet

Comments

You May Also Like

Related Searches

Check It Out

10 Delicious Game Day Eats That Rival the Game

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!