How to Preserve Logs for Campfire Seats

Save

The focal point of a camp is often the campfire. Images of conversation, cooking and poking at glowing coals with long sticks often come to mind. A traditional means of sitting around a campfire is on large, round logs. Although the larger round logs are often split into smaller pieces of firewood and kindling, a few of the logs survive to be used as seating. The sides of the logs are naturally protected by bark. However, the top and bottom of the log should be treated for long-term use.

Things You'll Need

  • Coarse sandpaper
  • Brush
  • Polyurethane
  • Place the log to be used as a seat on a flat and level surface. Position the log on its side so that the top and bottom are accessible.

  • Sand the top and bottom of the log with coarse sandpaper. Use the sandpaper to remove any debris that has accumulated since the log was cut and to rough the end cuts so the grain will accept the polyurethane.

  • Choose a clear polyurethane or one that is tinted in various wood colors, such as oak or walnut. Base your choice on your personal preferences.

  • Open the container of your polyurethane seal. Dip a brush into the polyurethane. Apply the polyurethane seal to the top and bottom of the stump with even brush strokes. Work the seal into the wood grain and along the edge where the bark is attached to the wood stump.

  • Allow the polyurethane to dry completely and then apply another coat. Repeat the process with three or more coats that will resist weathering and make a long-lasting log seat around the campfire.

Tips & Warnings

  • You can apply up to six coats of seal to your stump to ensure longevity.
  • If inclement weather pops up immediately after you've brushed on a coat of seal, tent some plastic over your log until the rain clears up.

References

  • Photo Credit Jupiterimages/Photos.com/Getty Images
Promoted By Zergnet

Comments

You May Also Like

Related Searches

Check It Out

10 Delicious Game Day Eats That Rival the Game

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!