How to Build a Portable Pool Deck

Save

We cannot always do things in a permanent way; sometimes the situation calls for a temporary or portable solution. Pool decks do not have to be elaborate or costly to be effective and attractive. A ground-level portable pool deck is inexpensive, easy to construct and can be assembled and reassembled in a different location with ease. The perfect solution, for a temporary situation, requires few supplies, little carpentry experience and a sunny weekend to complete.

Things You'll Need

  • Tape measure
  • Pine lumber, 6-by-3/4-inch
  • Pine lumber, 1 1/4-by-1 1/4-inch
  • Vise
  • Medium-grade sandpaper block
  • Scrap lumber
  • High-quality outdoor wood stain
  • Paintbrush
  • Electric drill
  • Screwdriver
  • Wood screws
  • Use a tape measure and pencil to mark three pieces of the 6-by-3/4-inch pine at 20 inches and 3 pieces of the 1 1/4-by-1 1/4-inch pine at 20 inches each.

  • Place the marked pine lumber in a vise to hold it. Carefully cut the six pieces. These six pieces, when put together, will form one 20-inch deck square. The wider pieces will form the top of the deck square and the smaller pieces will be the back supports for the deck square.

  • Using a medium-grade sandpaper block, sand all the wood pieces' edges until smooth.

  • Lay the wood pieces across the scrap wood and paint both sides with an outdoor wood stain. Allow the stain to dry overnight before continuing the project.

  • Repeat steps 1 through 4 for as many 20-inch deck pieces as needed to make the desired deck size. Use coordinating stain colors for a patterned effect.

  • Lay the three larger pieces on a working surface face down. Position the three pieces of smaller pine perpendicularly across the larger boards. There will be two even spaces between the larger boards and the pieces will form a square.

  • Mark and drill six countersink holes in each back support piece -- two for each wide board that the support piece crosses.

  • Use a screwdriver and wood screws to attach the top front piece to a back support piece, keeping the corners square. Screw the top back piece in a similar fashion.

  • Screw another back support piece to the opposite side.

  • Position the last top piece in the center and screw it to the two back support pieces.

  • Screw in the final back support piece in the middle of the square.

  • Repeat steps 6 through 12 for all stained deck pieces. When all deck pieces are complete, lay in an alternating fashion to form the deck.

Tips & Warnings

  • Use the deck on a flat surface or over an existing concrete slab.
  • Wear eye protection when operating power equipment.

Related Searches

References

  • "Garden Projects in a Weekend"; Julie London; 1998
  • "2x4 Projects for Outdoor Living"; by Henderson/Baldwin, 1999
  • Photo Credit Jupiterimages/Comstock/Getty Images
Promoted By Zergnet

Comments

Resources

You May Also Like

  • How to Make Portable Wood Decking

    Living in a rental property does not allow you to make permanent improvements. Building a deck is one of those things. You...

  • How to Build a Wet Deck

    A wet deck is defined as a shallow portion of the pool where people can wade or sit on deck furniture with...

  • How to Clean a Portable Pool

    Portable pools, also commonly called kiddie or baby pools, are small pools which can be set up and used and then easily...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!