How to Reset the Wipers on a GEM Car

A do-it-yourself wiper reset requires only a few simple steps.

Because the Global Electric Motocar, or GEM, runs solely on electricity, every component is run through the electrical system in some way. Problems can normally be corrected with some basic knowledge of electricity. If the wiper on the front of your GEM car is no longer working, there are just a few areas to check in order to fix the problem. Assuming that there is no large underlying problem, this job should take less than half an hour.

Things You'll Need

• Owner's manual (helpful but not required)
• 10 amp fuse
• Fuse puller

Instructions

1. Test the wiper by making sure the key is in the correct position for the car to run. Turn the key off.

2. Remove the cover of the fuse panel, located on the lower dash, by using the key that is used to start the vehicle and turning the lock one-quarter turn counterclockwise.

3. Locate the correct fuse by looking at the fuse map in the owner's manual of your GEM car. If no owner's manual is available, the wiper fuse is a 10 Amp fuse that is traditionally the second from the top in the left column of fuses.

4. Remove the fuse with the fuse puller and inspect to see if it is blown. Replace with a new fuse.

5. Test the wipers. After confirming that they are working, reinstall the fuse cover.

Tips & Warnings

• Ensure that your GEM has a full charge before attempting any fuse replacement. A weak battery could cause some electrical components not to function properly.

• Make sure the car is turned off before working with the fuse panel.

References

• 2010 GEM Owner's Manual

Resources

• GEM Auto Car Repair Index