The 1967 Ford Mustang was equipped with either two front bucket seats or with a single front bench seat as optional equipment. The seat assembly may be moved to adjust the position of the seat in relation to the dashboard. However, the back of the seat may not be adjusted. To move the seat, a lever underneath the front of the seat is pulled and the seat slides through two metal tracks. Over time, these tracks tend to corrode and the lever's spring can break. The tracks and the spring cannot be repaired unless the seat is removed.
Things You'll Need
- Safety stands
- Deep-set socket wrench
Raise the side of the Mustang from which the seat will be removed from with a jack. Position the jack's lift point underneath the frame rail rather than underneath the floor pan to prevent damaging the pan.
Lower the Mustang onto safety stands.
Locate and remove the four rubber grommets underneath the Mustang to access the seat's mounting nuts. A single grommet is located against the bottom of the floor pan at each corner of the seat. Pry the grommets off the floor pan with a flathead screwdriver. Remove the four grommets on the opposite side of the car if the Mustang is equipped with a bench seat.
Remove each of the seat's four mounting nuts with a deep-set socket wrench. If the Mustang is equipped with the bench seat, remove the four mounting nuts on the opposite side of the car as well.
Lift the seat straight up to remove it.
- "1967 Comet, Falcon, Fairlane and Mustang Shop Manual"; Ford Motor Company; 1967
How to Replace the Driver's Seat in a Ford Mustang
Removing the front driver's seat in a Mustang is rarely necessary. However, doing so is often required if you want to replace...
How to Install Seat Covers in a Ford Mustang
Installing seat covers in your Ford Mustang is an inexpensive way to customize the car. Perhaps you are not satisfied with the...
How to Remove a 1967 Mustang Door Window
Removing the door glass from a 1967 Mustang may seem like a perplexing task, particularly since there seems to be nothing holding...
How Do I Put Front Seat Belts in a 1965 Mustang?
The 1965 Mustang was equipped with only a lap belt as the shoulder belt was not used in the Mustang until 1968....
How to Remove the Windshield Wiper Arm on a 1967 Mustang
Removing the windshield wiper arm on a 1967 Mustang can be an easy process. What makes it difficult at times is the...
How to Change a Driver Side Window on a 2000 Mustang
If your driver-side window becomes damaged, it can put your vehicle at risk from further damage or theft. Changing the driver-side window...
How to Remove a '67 Camaro Front Clip
To remove the front clip from a 1967 Camaro, it is helpful to first understand what constitutes the parts which make up...