How to Install a DirecTV Dish in an Attic

Save

A DirecTV satellite system will not function if the receiver dish is not facing the low-earth-orbit satellite in space over the Gulf Coast. Installing the DirecTV dish in an attic provides protection from the elements for both the dish and the cables connected to it. The procedure avoids the eyesore of mounting the dish on the roof or side of the house. A few tools are needed as well as some bricks from a hardware or cement supply.

Things You'll Need

  • Satellite receiver
  • Cell phone
  • Assistant
  • Coaxial cable, 100 feet
  • No.10 Torx screwdriver
  • Portable drill
  • 4-inch drill bit
  • Bricks
  • Go to a satellite dish location guide website, for example, the AntennaWeb website (see Resources). Click on the "Satellite Dish" location screen. Enter your Zip code and that DirecTV is your satellite service provider in the appropriate text fields to learn the direction the satellite dish must be pointed to "see" the satellite. Memorize this direction.

  • Stand the DirecTV satellite dish bracket on the floor of the attic next to a window facing the direction of the satellite that will provide the transmission to the dish. Place bricks on the bottom of the bracket to hold it steady.

  • Loosen the screws on the collar at the top of the bracket with the Torx screwdriver. Insert the pole at the base of the satellite dish through the collar. Push the pole all the way into the bracket. Tighten the screws.

  • Loosen the screws on the front collar of the dish with the Torx screwdriver. Insert the end of the lateral transponder arm into the collar. Tighten the screws.

  • Loosen the screws on the side of the transponder with the Torx screwdriver. Slide the transponder onto the free end of the lateral transponder arm. Tighten the screws.

  • Drill a hole in the attic floor against the wall where the satellite dish is located with the portable drill. Screw in one end of the coaxial cable into the coax output on the transponder. Snake the coaxial cable through the hole in the attic floor and down to the DirecTV satellite receiver on the lower floor. Screw the end of the coaxial cable into the coax input on the back of the satellite receiver.

  • Turn on the satellite receiver. Press the "Menu" button. Select "System Setup," then "Point Dish/Satellite." Have your assistant sit in front of the satellite receiver. Go to the DirecTV satellite dish. Call the assistant on the cell phone.

  • Loosen the two knobs on the side of the bracket. Align the front of the dish toward the satellite by adjusting the height and lateral position while your assistant on the phone tells you whether the signal meter on the receiver is showing an increase or decrease in strength. When the signal is strongest, lock down the knobs to secure the DirecTV satellite dish.

Tips & Warnings

  • The DirecTV satellite dish should have an unencumbered view of the sky -- it may not work through a wall or any obstruction that is between it and the satellite.

References

Promoted By Zergnet

Comments

Resources

You May Also Like

  • How to Install a TV Antenna in the Attic

    Whether for aesthetic reasons or for practical reasons, you may find it necessary to mount a TV antenna in your attic. Given...

  • How to Align a Direct TV Dish

    Installing a satellite dish can not only be rewarding financially by saving you money on installation fees, but it is also a...

  • How to Install DirecTV

    While DIRECTV offers installation specials, installing your own satellite dish allows you to pick the location based on your own knowledge of...

  • How to Wire DirecTV

    Wiring a DirecTV dish involves connecting it to the DirecTV receiver in addition to running a cable to the television. See a...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!