Small punctures and pinholes in pontoons might not be immediately noticeable, but can still cause you to take on enough water to cause problems. Eventually, water in the pontoons can cause increased gas consumption due to the extra weight. Steering can also be affected due to the weight distribution becoming uneven. It can also cause the boat to sit too low in the water, and potentially to go under.
Thus, it is good to repair pontoon leaks early on, before a small enough issue becomes a much larger one.
Things You'll Need
- Self-hardening plastic metal (putty)
- Epoxy waterproof sealer
- 18, 24,or 36 grit sandpaper
- No-sand fiberglass primer
- Fiberglass anti-fouling bottom paint
- Disposable non-foam rollers
- Disposable paint brushes
- Dust mask
Clean the area of and around the leak thoroughly.
Sand the area to give the repairing compounds a good surface to stick to. It should not be too smooth, but should not have rough edges.
Fill small punctures with putty, according to its directions. Allow the putty to cure, then sand it to smooth. For areas with pinholes, mix putty with prepared epoxy sealer to a rollable consistency, and then roll and/or brush it to cover the area.
Wait for the putty and epoxy to dry. Sand it to roughen the surface slightly. Apply a coat of epoxy sealer over the area with a brush and/or roller, and wait for it to dry before proceeding.
Cover the area with a coat of no-sand primer and allow it to dry according to its instructions. The primer and paint for fiberglass hulls works in this instance because you are covering the putty and epoxy, not the metal.
Paint the area with a coat of fiberglass anti-fouling bottom paint. Allow it to dry.
Tips & Warnings
- Depending upon where the leak is located on the pontoon, it may be helpful to use jacks, wenches and other equipment to take the pontoon off of its trailer (in the absence of a boat lift), and to put it on a stand for easy access. This can be a big job, and can also be dangerous, so extreme caution is recommended. If at all possible, repair larger boats while on their trailers.
- Photo Credit Arthur Tilley/Creatas/Getty Images
How to Repair Aluminum Boats
One rather costly item that you can learn to repair yourself is an aluminum boat. Aluminum boats luckily are pretty sturdy boats...
How to Repair a Damaged Pontoon
Pontoon boats maintain their buoyancy by means of air-filled aluminum pontoons placed beneath the deck. These types of boats are great for...
How to Repair a Dent in a Pontoon Boat
Dents are an inevitable aspect of ownership when it comes to pontoon boats. Regardless of how careful you are, at some point...
How to Repair an Aluminum Boat Leak
Aluminum boats are favored for their lightweight construction, but this asset also becomes a liability regarding the boat's structural strength. Aluminum boats...
How to Fix Water Leaks With Expanding Foam
Water leaks in concrete are common in basements that have begun to age. Using expanding polyurethane foam is one of the best...
How to Seal Aluminum Pontoons
A leaky aluminum pontoon can lose its buoyancy if damaged areas aren't repaired in a timely manner. Putting off a repair only...
How to Repair a Pontoon With Foam
The foam used to repair a pontoon boat leak comes in the form of a liquid. Once released from its canister, the...
Types of Pontoons for Pontoon Boats
The pontoon-boat design uses floats under a flat-bottomed water craft to add buoyancy. The origin of the name dates to the French...