How to Install Motorcycle Graphics

Vinyl graphics can liven up a boring paint job.

Motorcycle graphics are a cost-effective way to embellish your motorcycle. Vinyl graphics are far cheaper and easier to apply than a new paint job and they are available in numerous designs and colors. Many companies will custom design graphics tailored to fit your motorcycle.

Things You'll Need

• Paper towels
• Isopropyl alcohol
• Tape Measure
• Squeegee

Instructions

1. Clean the area where you will be laying down the graphics. Wet a paper towel with isopropyl alcohol and thoroughly clean the surface. Any dust, dirt or bugs on the motorcycle can affect the appearance of the graphic. Allow the alcohol to dry completely.

2. Measure where you will be laying the graphic so that it is even. Ensure that the graphic is centered from the top and bottom and left and right on the section of the motorcycle you are placing it.

3. Peel the graphic from the backing paper gently without letting it touch any other surface while you remove it.

4. Align the graphic to the area you previously measured and begin laying it down. As you lay it down, smooth it out with the squeegee. The squeegee will help stretch the vinyl over curves on the motorcycle and prevent bubbles from getting stuck beneath.

5. Rub the decal flat, working from the middle to the outside. Use your fingertips first and then go over any rough spots or bubbles with the squeegee, pushing them out to the edge.

References

• Tattooed Ride: How to Apply Motorcycle Graphics
• Graphic MX: Vinyl Graphics Application Instructions