How to Make an Electronic Vaporizer
Vaporizers are best for heating water until it turns into steam. The best thing about the different herb and beauty vaporizers is that they heat the herbs and leaves instead of burning them. As a result, the vapor that evaporates brings health and skin benefits along with refreshing smell of the herbs. Buying an electronic herbal vaporizer can prove expensive for your pockets. Follow these steps for making an electronic vaporizer in your home. Does this Spark an idea?
Other People Are Reading
Things You'll Need
- Get 29.5 inch board
- Clamps (minimum 6)
- Drill
- Food jar
- Two wire screws
- Three wooden screws
- Brass bolt
- Brass pipe
- Paint and wood stain
Instructions
-
-
1
Split the board into five separate boards with measurement of 7.37 inches in such a way that the ends of four lengths are exactly bent towards 45 degrees. Start gluing the ends to all the beveled edges that are spilt by you.
-
2
Paint the food jar lid and stain the box after the glue is set.
-
-
3
Drill five holes in the jar lid. The first hole should be at the center of the lid, second hole off the nylon tubing center, third one at the edge of the jar lid, fourth hole at the side of the box to let the iron cord pass and the fifth one at the center of the box to meet the heating end of the box. Additionally, you have to drill hole in the center of the brass pipe after finishing the above procedure. The diameter of the brass bolt should be at the center of the brass pipe.
-
4
Remove the soldering iron tip and try to center end of the pipe to the heat end of the soldering iron. Now, attach both of them using a bolt. Then, ribbon an inch of filling from all four ends after cutting the soldering iron from the handle.
-
5
Align the lid with two holes with the help of a driller. Center the lid to mark the hole for tubing purposes. Now, try to attach it with different wood screws.
-
6
Merge the cord by turning the box on a side after feeding the soldering iron cord from the center of top box. Don’t forget to feed the cut end of the cord from side holes.
-
7
Fasten the food jar after twisting the box upright and positioning the lid end exactly under the heating end soldering iron.
-
8
Attach the electric wire to test its working condition. You can test it by feeding it different herbs.
-
1
