The purpose of a cooker hood is to prevent cooking odor and air pollution in your kitchen while cooking. This appliance is installed directly over the stove to trap the pollutants such as grease, moisture, fumes and heat through duct work to the house exterior. It takes less than two hours and virtually no prior experience to install a cooker hood. You can direct the fumes out the top or back via cooker hood ducts. However, for optimal range hood efficiency, run the duct to your home's exterior through the wall directly behind the unit in the shortest straight distance possible.
Things You'll Need
- Safety glasses
- Work gloves
- Carpenter's level
- Electric drill
- Long saw
- Exhaust duct
- Duct tape (as needed)
- Duct cap
- Silicon caulk
- Extension cable (as needed)
- Electrical wire clamps
- Color-coded, spliced wire caps
Place the hood upside down on a flat surface. Remove the filter, fan, duct connector-damper and the electrical box cover on the inside of the hood unit. Wear safety glasses and gloves.
Choose a plugged opening that fits with your plans for the exhaust vent; most cooker hoods come with more than one opening on the side and at the top. Use a screwdriver or hammer to punch out the plug. Reinstall the duct connector-damper to the hood.
Get an assistant to hold the hood in place while you use a level to adjust its position before marking it on the wall. Trace the opening onto the wall with a pencil.
Make holes on each corner of the reference lines with a long-bit drill. Drill all the way through the exterior wall.
Go to the outside wall and connect your drilled holes by drawing lines between them, using a marker or pencil. Cut the exterior wall with a long saw (i.e. saber saw), reciprocating saw or keyhole saw. Discard any insulation and debris between the walls that would interfere hood installation.
Push the duct cap onto one end of the duct and then insert the duct into the wall, with the cap facing toward you. The duct should reach your cooker hood exhaust opening. If not, you will need to purchase a longer duct. You may need to have the duct go around a wall stud if it is in your way, using duct tape to seal the joints. Fasten the duct cap to the exterior wall with screws. Apply silicon caulk all around where the duct cap and the wall meet.
Turn off circuit breaker to the kitchen. Attach electric cable to your cooker hood from a nearby junction box or receptacle through the hole in the wall. An extension cable may be needed if the wall cable is too short. Strip the cable sheathing to expose the wires, using electrical clamp and pass the cable through the electrical knockout on your cooker hood.
Have your assistant hold the cooker hood in place while you secure it by driving screws into nearby cabinets or wall studs.
Splice the black wire from the power source to the black lead, the white wire to the white fixture lead, and the ground wire to the green lead. Attach a color-coded wire cap on the exposed lead of each spliced wire. Tuck the wires into place before replacing the electrical box cover.
Reinstall the fan and filter to the hood. Turn on the power and test your cooker hood.
Tips & Warnings
- Many cooker hoods ship with exhaust duct and duct cap from the manufacturer. You can purchase these in hardware stores if your unit did not come with them.
- Cutting through a brick or cement exterior wall is a challenge. Use a masonry bit drill for drilling holes, and a brick hammer or cold chisel to cut an opening through these kinds of walls.
Standard Range Hood Duct Sizes
Range hoods remove pollutants and odors from kitchens by venting smoke and airborne grease outside through metal ducts of various standard sizes....
How to Install a Range Vent Hood
How to Install a Range Vent Hood. Installing a range vent hood is a necessity if you want to vent cooking odors...
How to Install Range Hood Ducts
A vented range hood can be an asset to any kitchen by drawing away heat, smoke, grease and steam. It can make...
How to Install an Island Hood
An island hood in your kitchen is a functional showpiece. Island hoods are a nice add-on for kitchens that are being remodeled...
How to Clean Stainless Steel Cooker Hoods
Stainless steel cooker hoods blend well with the other stainless steel appliances in your kitchen. Splashes from food and grease show up...
How to Install a Kitchen Extractor Fan
Installing a kitchen extractor fan, also called an over-the-range hood, will take fumes, exhaust and vapor from your kitchen oven or range...
Installing a Microwave Over the Range
Cluttered counter space in your kitchen is enough to drive any cook a little bit crazy. When you find yourself glaring at...