Troubleshooting the fuel-injection system in the Ford Ranger can be a daunting task. Understanding how the system functions makes this system easier to diagnose and repair. High-pressure fuel is supplied to the fuel injector by the fuel pump. Just before and during the opening of the intake valve, an electrical pulse is sent to the injector and the injector opens to allow fuel to be sprayed into the cylinder. Diagnosing the system includes checking fuel supply and electrical function.
Things You'll Need
- Fuel-pressure test set
- Automotive circuit tester
- Injector-harness tester (noid light)
- Digital volt/ohmmeter
Attach the fuel-pressure tester gauge to the test port on the fuel rail attached to the injectors. Cycle the ignition key from off to on several times to pressurize the system. System pressure should be greater that 45 psi. If no fuel pressure develops in the system, the most likely causes are the fuel-pump fuse, fuel-pump relay, or fuel pump.
Check the fuel-pump fuse at the the under-hood fuse block using the circuit tester. If the fuse is good, have a helper turn the ignition key to the start position and check for power supply at the fuel-pump electrical connector located near the rear of the fuel tank on the frame. If power is supplied to the pump but the pump doesn't come on, replace the pump. If no power is supplied to the pump, replace the fuel-pump relay. If fuel pressure is normal go to the next step.
Unplug one of the wiring-harness connectors attached to the fuel injectors. Plug the injector-harness tester into the harness connector. Have a helper turn the ignition key to the start position while you observe the tester. If the tester does not flash during cranking, check for power at the harness. One wire of the connector should be power and the other should be ground during cranking. Check the fuses if there is no power. Replace the ignition module if there is power supplied to the injector but no ground during cranking.
If the engine runs, but has a misfire, test the injector by measuring the resistance of the injector. Remove the wiring connector from the injector and touch the leads of the digital volt/ohmmeter to the pins in the injector. Readings of 0 ohms indicate a shorted injector and readings of infinite resistance indicate an open injector. Resistance values of 10 to 16 ohms are normal.
Where Is the Fuel Shut-Off Valve on a 1989 Ford Ranger?
Your 1989 Ford Ranger is equipped with a fuel cutoff switch for your protection. In the event of an accident, the switch...
How to Diagnose Fuel Injector Problems
Fuel injectors can cause a whole host of problems that can lead to major engine damage if not diagnosed and replaced or...
How to Replace a Fuel Injector in a Ford Explorer
The Ford Explorer mixes fuel and air under pressure with a fuel injector. This function was previously performed passively by carburetors until...
How to Remove and Clean the Injectors in a Ford Ranger
Cleaning the fuel injectors on the Ford Ranger is a straightforward process that involves simple steps and tools. The Ranger is identical...
How to Test a Fuel Pump Relay on a 94 Ford Ranger
A broken fuel pump relay causes a malfunctioning pump, starving the engine of fuel. The engine may stutter, stall or not start...
How to Replace Duramax Injectors
The Duramax engine is an eight-cylinder diesel engine from General Motors that has been in production since 2001. General Motors uses it...
What Are Some Signs of a Bad Fuel Pump Filter?
The fuel pump on a motor vehicle pumps the gasoline through the engine to be ignited and create power. The fuel must...
Ford Ranger 3.0 Fuel Injectors Removal
You can replace one or more fuel injectors on your Ford Ranger 3.0 model. They are readily accessible through the top of...
Ford Ranger Fuel Pump Troubleshoot
The Ford Ranger is designed with the fuel pump installed in the fuel tank. The pump engages when you turn the key...