The key to drilling near an electrical outlet is knowing exactly where the electrical wiring is located inside the wall. Using a electronic stud finder that has a built-in wire-detection mode is a great way to identify the specific location of the wires hidden behind the wall. This will allow you to mark on the wall the location of wires, giving you a visual representation of where it is safe to drill.
Things You'll Need
- Electronic stud finder with wire-detection mode
- Pen or pencil
- Battery-powered rill with drill bit
Check your circuit breaker to ensure that power is being supplied to the outlets that will be drilled around.
Turn the electronic stud finder on, and, depending the model, make sure the selector switch is pointed to wire-detection mode.
Start on the left side of the outlet and hold the stud finder against the wall, slowly moving it in a left-to-right pattern. Each time the light indicates a wire, mark that exact position on the wall. Repeat this process as you work your way completely around the outlet in a 12-inch diameter, marking each location of wires. When complete, you should have a pattern marked on the wall where each wire is running.
Turn the power off at the main circuit breaker panel which supplies the outlet that will be drilled next to.
Position the drill bit on the wall so that it is clear of the marked patterns of the wiring, and as close to the outlet as possible. Drill through the wall, repeating this step to drill as many holes as needed for the project.
Turn the power back on once the necessary holes have been drilled and the project is complete.
Tips & Warnings
- You could also use a tone generator, available at your local hardware store, to plug into the outlet and determine where the wires are located based on the tone generated by the equipment.
- Avoid drilling too close to electrical lines even with the wire locations marked on the wall. Always turn the power off, as failure to do so could result in accidental electrocution.
How to Change Electric Hand Drill Bits
An electric hand drill is one of the most versatile tools you can have in your garage. It can be used to...
How to Be Safe Around Electricity
While we all depend on electricity in many aspects of our lives, we can often take it and its safety for granted....
How to Install an Electrical Floor Outlet
Sometimes an electrical outlet in the wall isn't quite right for your electrical needs, and you need an electrical appliance or device...
How to Install Electrical Wire Under Flooring
Running electrical wires between the subfloor and the surface layer of flooring is not safe, but you can run them under the...
How to Detect an Electrical Wire in a Wall
Beginning a remodeling project or simply drilling into a wall to hang a picture can seem simple enough, but steps must be...
Mold & Mites in the Walls Behind Electrical Outlets
Mold and mites are two nuisances that can cause homeowners headaches. Mold is a type of plant fungus that can decay walls,...
Drilling a Hole in the Ceiling or Floor for an Electrical Outlet
Drilling a hole in the ceiling or floor for an electrical outlet is sometimes necessary, learn how to install and wire a...