A traditional picket fence was used to keep small animals from escaping into the wilds, and intended to be a low-cost type of fence. Today, making the panel for a picket fence is a low-cost alternative to buying panels that are already constructed. Choose an appealing rough-cut lumber for the pickets, cut your own pattern into the top, and put together a fence that is not only functional, but gives you the satisfaction of having done the task yourself.
Things You'll Need
- Tape measure
- Bevel square
- Circular saw
- 1/2-by-3 1/2-by-33-inch pickets
- 2-by-2-inch fence rails
- Framing square
- 4d Nails
Determine the number of pickets needed for the fence. To calculate this, measure the length and divide the total number of inches by six. This number includes the picket width plus the spacing between pickets.
Make two marks 3 inches down from the top of each picket, with the marks placed on the outside edges. Make another mark at the top center of each picket. Set the bevel square for an angle that runs from the center top point to the mark at either side of the board. Mark this pointed wedge shape on all picket tops. Use the circular saw to cut off the marked areas, leaving a sharp central tip on each picket.
Mark the top of the pickets 8 inches down from the point, and mark the bottoms 8 inches up from the lower edge. Make the same mark on the outside edges of all of the pickets. These two lines will allow you to line up the pickets on the rails for easy, accurate placement. Measuring from one end of rails, make a small mark on the rails every 6 inches along the length. This will be your guide for mounting the pickets upright.
Place two of the fence rails on a flat surface, spaced 13 inches apart. Place two pickets so that the outside edge of each is 6 inches inset from the ends of the rails. Use two 4d nails on each picket at the juncture of each rail. Use the framing square to make certain your pickets are placed at a true 90-degree angle on the rails. If all of your marks and measurements are correct, checking the angle is not necessary, but this gives you a way to double-check your work as you go.
Space the pickets out so that the marks on the pickets line up with the rails, and each picket lines up with a mark on the rails. Attach the pickets with a pair of 4d nails at each rail and picket junction.
When the picket fence panel is mounted, you will need one additional picket at each end of the panel. These pickets hide the joints in the rails, and will not be put on until after the panel has been mounted on fence posts.
Tips & Warnings
- Note that the end pickets will have slightly larger gaps on either side of the pickets, due to the picket being placed centered over the rail joints. This discrepancy will not be noticeable as the wider fence posts will actually make the gaps seem slightly narrower.
- Instead of wedge shaped tips, use a jigsaw and cut curved patterns or make your own unique fence-top designs.
How to Build Fencing Panels
Preparation is one of the most essential parts of any woodworking project. When building a fence, it is always a good practice...
How to Build a Wood Picket Fence Gate
The gate for a picket fence is not usually meant to provide much of a barrier, but to offer more of an...
How to Install Picket Fence Panels
Picket fences are functional and decorative ways to enclose a space. While you can build a picket fence out of wood, you...