How to Punch a Square Hole in Metal

Save

Some automotive parts require a square pass-through hole in either a sheet metal panel or other metal component. Generally, punching a square hole in sheet metal requires a mechanical punch and a square punch and die set. This is an expensive tool, especially if you only need to punch one or two holes. An alternative tool is slower than a mechanical punch but is cheaper in cost and creates a clean square hole in a piece of sheet metal.

Things You'll Need

  • Masking tape
  • Fine-tipped permanent marker
  • Safety glasses
  • Manual square punch
  • Drill bit set
  • Variable-speed drill motor
  • Socket set
  • 3/8-inch ratchet
  • Adjustable wrench
  • Place a piece of masking tape on the surface of the sheet metal, over the spot that you will be punching the square hole. Mark the center of the square hole with the fine-tipped permanent marker.

  • Put on your safety glasses. Read the operating instructions enclosed with the manual square punch to determine the size of the pilot hole needed for the square punch.

  • Secure the appropriate-sized drill bit into the chuck of the drill motor and place the tip of the drill bit onto the mark you made on top of the masking tape in step two. Depress the trigger of the drill motor to drill the pilot hole through the sheet metal.

  • Take apart the square punch as described in the operating manual of the punch. Slide the mandrel of the square punch through the pilot hole you drilled through the sheet metal and reassemble the manual square punch.

  • Match a socket from the socket set with the hex nut located on the top of the square punch, attach the socket to the 3/8-inch ratchet and slide the socket onto the hex nut.

  • Place the adjustable wrench onto the bolt head of the manual square punch and turn the ratchet clockwise to tighten the mandrel of the punch. Continue tightening the mandrel until the square punch pops through the sheet metal and creates a square hole in the sheet metal.

References

  • Photo Credit Jupiterimages/liquidlibrary/Getty Images
Promoted By Zergnet

Comments

You May Also Like

  • How to Clean Punched Tin Panels

    Punched tin was commonly used as inserts in the doors of cabinets, cupboards and pie safes in the days before refrigeration. Tin...

  • How to Use Carriage Bolts in Metal

    Carriage bolts are made with a square seat beneath a round unslotted head. In wood, tightening the nut pulls the shoulders of...

  • How to Punch Holes in Electrical Panels

    Electrical conduit and connectors come in standard sizes. Common sizes of conduit used in residential construction are often larger than readily available...

  • How to Drill a Hole in Metal

    If you try to drill through metal with the same tools and techniques that you would use to drill through wood, you...

  • How to Drill a Square Hole

    There is a type of bit that drills square holes. It's not magic, it's a drill bit inside a square box that...

  • How to Make Square Holes in Sheet Metal

    Cutting a square hole in sheet metal can be a difficult process. If you are not equipped with the correct tools, the...

  • How to Punch Holes in Aluminum

    Reasons for punching holes in aluminum include making mounting brackets, creating venting in an enclosure and building your own passive solar heating...

  • Hole Punch Tools

    Whether you're making holes in paper, leather or metal, there is a tool for any punch. One of the earliest forms of...

  • Metal Punching Tools

    Metal punching tools are designed to punch holes through several types of metal. Hand held punches are mainly used for making jewelry....

Related Searches

Check It Out

How To Travel For Free With Reward Points

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!