Wall panels, such as wainscoting, that have been installed in a mobile home may need to be replaced if they are old, discolored or have become damaged. This will require you to measure the height and width of the walls of your mobile home to determine how many panels will be required. You will then need to take all decorations and light fixtures off of the walls before starting the project.
Things You'll Need
- Pry bar
- Tape Measure
- New panels
- Circular saw
- Power drill
- Construction adhesive
- Finish nails
Take off any wood battens that were used to cover the seams of the panels. Insert the pry bar under the batten and pry it off of the paneling.
Remove the existing paneling in your home with the pry bar. Place the end of the pry bar in between the seams of the panels and strike it with a hammer to force it under the panel. Push the pry bar until the panel begins to separate from the wall.
Measure the height that is needed for the new panels with a tape measure. Mark the measurements on the new panels with a pencil.
Cut the new panels to the proper length by using a circular saw and cut along the pencil mark.
Draw a template on a piece of paper to mark the location of outlets and switches on the wall. Draw an outline for the switch and outlet on the paneling. Drill access holes in each corner of the outline with a drill. Insert the jigsaw into one of the access holes and cut around the outline.
Apply construction adhesive to the back of the paneling and press it against the wall and then pull it off. Wait for about 30 seconds for the adhesive to start to set and then press the paneling firmly against the wall.
Set additional panels on the walls so that the edges of the panels overlap slightly.
Secure the panels by hammering a finish nail into the top and bottom edge where the panels overlap.
Place new battens over the seams and secure them with the finish nails.
Tips & Warnings
- Use screws with a power drill if you do not want to secure the panels or battens with nails.
- If you do not take measurements correctly, you can end up with panels that will not fit.
- Photo Credit Jupiterimages/Comstock/Getty Images
How to Fix Holes in Mobile Home Walls
Unsightly and annoying holes in the walls of your mobile home can be repaired in several ways. The types of paneling and...
How to Replace Wall Studs in a Mobile Home
Mobile home wall studs become damaged or warped over time causing lumps in the wall covering. If the wall bows out too...
How to Paint the Paneling in a Mobile Home
Most mobile homes don't have heavy sheetrock walls; instead they have paneling nailed directly to the wall studs. Mobile home paneling is...
How to Replace Mobile Home Paneling With Drywall
Mobile home paneling is beautiful when it is brand new. However, over the years it fades and becomes dull. The finish gets...
How to Repair a Wall on a Mobile Home
If you need to repair a wall in your mobile home, replacing paneling or sheetrock can create problems. Most mobile homes are...
How to Replace a Wall Light Switch in a Manufactured Home
Most light switches in manufactured homes are single pole switches. When these types of switches become faulty you will need to replace...
How to Remove & Install Mobile Home Walls
The construction of a mobile home or double-wide takes place on an assembly line. Typically, vinyl flooring is rolled across the entire...