Windows are subject to the outside elements constantly. This causes the wood components and rubber seals to deteriorate. When the seals fail and the wood framing rots, the barrier that windows provide is compromised and the outside elements find their way indoors. Pre-hung window inserts are an affordable alternative to replacing the entire window. A pre-hung window insert allows you to have the benefits of a new window without the need to replace the trim around the window, disturb the exterior trim or damage the interior wall finish. Pre-hung double-hung window inserts are packaged with the hardware necessary for installation.
Things You'll Need
- Tape measure
- Utility knife
- Pry bar
- Putty knife
- Combination square
- Fiberglass batt insulation
- #2 Phillips tip
- 2 inch finishing nails
- Caulk gun
Cut the seal between the window stops and the window frame. The window stops are wood or plastic strips that hold the window in place. Window stops are roughly 1 to 1 1/2 inches thick and are nailed to the window frame. Slide the pry bar or putty knife under each window stop and pry away from the window frame.
Remove the parting stop located from the groove in the window frame with the putty knife. Cut the balance cords if they are accessible. Remove the lower window sash from the window frame. Lower the upper sash and pull it towards you to release it from the window frame.
Lay a two-inch wide bead of caulking on the base of the window frame. Start the bead at the left vertical side of the window frame at the exterior window stop. Drag the caulking gun across the base of the window frame. Run the bead of caulk towards you two inches and continue the bead across the window base, remaining two inches away from the exterior window stop. When you reach the other vertical side of the window frame, run the bead of caulk back to where you started.
Set the pre-hung window insert into the window frame. Make sure that the pre-hung window insert is tight against the exterior window stop. Run screws into the pre-drilled holes in the window insert. Do not tighten the screws all the way. Insert the shims between the pre-hung window insert and the window frame. Use the level to level the pre-hung insert. Tighten the screws to secure the window.
Place the batt insulation around the window insert. Do not over pack the insulation. Over-packed insulation could bow the upper frame of the window insert.
Install the interior window stops. Use the hammer and finishing nails to secure the window stops to the existing window frame. Test the operation of the window. If the window binds, check the window for square. To check the window for square, measure diagonally between two opposing corners. Then measure between the other two corners. If the measurements are equal, the window is square.
Caulk around the window after it is square and operates smoothly. You will need to caulk the area where the window stops meet the pre-hung window insert. Move to the exterior of the window and caulk the exterior window stops to the pre-hung window inserts.
How to Install a Prehung Door
Buying a prehung door, in which the door comes already hinged to the framed-up door casing, is a little more expensive than...
How to Install Replacement Windows
Installing new windows can help make a house more energy efficient and improve its appearance. However, many homeowners are reluctant to replace...
How to Install Pella Replacement Windows
Modern replacement windows are fundamentally different than the old-fashioned, wood-sash windows they replace. Instead of being installed in separate pieces, replacement windows...
How to Install Exterior Prehung Doors
To successfully install an exterior prehung door is a matter of ensuring the unit is held plumb and square as it is...
How to Install Pre-Hung Double Doors
Installing pre-hung double doors is pretty much the same process as installing regular pre-hung doors. In both instances, the doors come already...