How to Chip the Xbox

The Xbox 360 is often referred to as a modder's dream. This system is a complete personal computer that is comparable to many high-end systems from the early 2000s. Although modding your Xbox 360 in any way nullifies the manufacturer's warranty, the benefits often outweigh the potential risk. A properly modded Xbox can play games from other regions (bought overseas), games in development, as well as backups of your games (copied games). You can even play some personal computer games directly on your Xbox.

Difficulty: Moderately Challenging

Instructions

Things You'll Need:

• Xbox 360
• Phillips-tip screwdriver (1/8 or 3/8 inch)
• Torx screwdriver (3/16 inch)
• Xecuter 2.6 LITE modchip

1. Remove the UPC sticker from the back of your Xbox to access the Torx screws.

2. Open the Xbox case by removing all six Torx screws.

3. Using the Torx screwdriver and Phillips, unscrew the DVD player and hard drive, placing them to the side. You do not need to remove the IDE or power cables.

4. With the motherboard exposed, locate the BIOS chip. This is located next to the fan and processor and will be labeled "BIOS 687-XX-XXX-XXXX."

5. Use the Phillips to pry out the BIOS chip gently.

6. Plug the Xecuter 2.6 LITE into the slot where the BIOS chip was just removed.

7. Carefully replace the DVD player and hard drive.

8. Close the Xbox casing and replace all six screws.

Tips & Warnings

• You can download virtual chips that flash your BIOS, allowing you to used burned Xbox games. This is often superior to installing a separate chip, which can damage your Xbox. The Xecuter 2.6 is one of many available mod chips, but this one requires no soldering.
• Opening your Xbox casing voids the manufacturer's warranty.

References

• Opening the Xbox
• About Xbox Modding

Resources

• Xecuter 2.6 LITE Chip