How to Use a RIDGID Manual Pipe Threader
Whether your project consists of many pipe joints or you only have to thread a single male end, a manual Ridgid pipe threader can make fast work of that task. A Ridgid manual pipe threader generally comes in a single handle unit that will contain interchangeable-sized dies for threading different diameters of pipe for male threads. All pipes must use the correctly sized dies for that diameter of pipe. By following a basic process, you can thread a pipe end in a matter of a few minutes.
Things You'll Need
- Pipe section
- Pipe vise
- Ridgid pipe reamer
- Pipe lubricant
- Ridgid pipe threader (die of same diameter as pipe)
Instructions
-
-
1
Place the length of pipe you want to thread into the pipe vise and tighten the screw handle so the pipe is held securely.
-
2
Insert the conically shaped pipe reamer into the end of the pipe you want to thread and turn the reamer in a clockwise direction. Remove any raised portions on the inside of the pipe so the interior wall is smooth and free of any debris.
-
-
3
Remove the reamer from the pipe and set to the side. Apply a small amount of lubricant to the end of the pipe. The lubricant will help in allowing the threader dies to cut the metal for the pipe threads.
-
4
Place the manual threader over the end of the pipe and turn the "directional" button toward the arrow side of the threader. The directional arrow button allows the manual threader to cut the threads and the handle be returned in a ratchet-like motion.
-
5
Use the clean rag and push against the end of the threader while turning the handle in a clockwise rotation. Continue to do so until the thread dies engage the metal of the pipe. Squirt some more oil on the pipe as you continue to operate the manual threader, cutting the male threads on the end of pipe.
-
6
Continue cutting the threads until the die reaches the end of the pipe. This will be indicated by the rear end of the manual threader coming in line with the end of the pipe. Turn the directional arrow button to the reverse side and turn the handle of the manual threader in a counter clockwise direction. The manual threader should easily screw off.
-
7
Squirt some more oil on the new threads and clean with the rag. The threads are now ready to be used for your project.
-
1
Tips & Warnings
Ridgid manufactures different types of dies for different types of pipe material. In other words, common steel dies should not be used on stainless steel pipe.
