With each use, a chainsaw will pick up sap and resin from wood and will get gummed up with a mixture of sawdust, dirt and chain lubricant. If you want to get peak performance out of your saw every time, you'll have to make the commitment to keep it clean. Cleaning a chainsaw chain isn't particularly difficult, however, and it doesn't require the use of any special solvents. Just read on to learn how you can clean yours in a matter of minutes.
Things You'll Need
- Chainsaw with dirty chain
- Soft bristle brush
- Old towel
- Plastic tray
- Bar and chain oil
- Paper towels
Make sure that the chainsaw is turned off. To be on the safe side, disconnect the spark plug wire from the chainsaw engine, making it impossible to accidentally turn on. If you cannot locate the spark plug wire, refer to the technical diagrams in your chainsaw's user manual.
Loosen the chain adjustment knob on your chainsaw until there is enough slack on the chain to allow you to slip it off of the guide bar. Completely remove the chain from the saw.
Create a mixture of one cup of household ammonia and one gallon of water in a plastic bucket. Soak the chain in this solution as you carefully scrub one section at a time with a soft bristled brush. Continue soaking and scrubbing until the chain sparkles and appears to be grit-free.
Rinse the chain thoroughly under running water. Dry it immediately with an old but clean towel, making sure that all of the moisture has been sopped up before you proceed.
Lay the chain in a plastic tray and pour some bar and chain oil over it until the chain is at least halfway submerged. After about three hours of soaking, turn the chain over to soak the other side. After this final soak, lift the chain out of the oil and let the excess drip off into the tray. Lightly dab the chain with clean paper towels until it no longer drips, then reinstall it on your chainsaw.
How to Clean Sap From a Saw Blade
If you’re sawing through a tree or log and notice that the saw is feeling unusually sticky, pull the blade out and...
How to Clean Saw Blades
Cleaning saw blades is a simple procedure, but it is very important to use the proper cleaners and never use metal tools...
How to Clean the Carburetor on a Stihl Chainsaw
The carburetor on a Stihl chainsaw channels a mixture of two-cycle oil and gasoline into the engine. That mixture, plus dirt or...
How to Clean a Chainsaw Gas Tank
You should drain a chainsaw’s gas tank if the saw is going to go in storage for the season or remain unused...
How to Do Chain Saw Maintenance
Chain saw maintenance includes keeping the air filter clean, regularly removing and cleaning the spark plugs, sharpening the blade regularly and dusting...