Building your own motorcycle exhaust is a project that takes some specialized tools, like a pipe bender, steel bender or welder and if you want chrome, you have to do the plating yourself, or take your pipes to a metal shop where they will plate your pipes for a fee. We will look at how to build the basic exhaust, but how you paint it is up to you.
Things You'll Need
- Steel pipe
- Paper or poster board
- Pipe bended and heat source
- Hardware and attachments
Measure your bike from the head pipe connection on the engine down to the foot pegs and then to the rear. Now sketch out a basic shape for your exhaust, using these measurements as a guide.
Build a full size template for your exhaust system on poster board, cardboard or plywood. Use a heavy marker, and be very precise with your measurements. Have a friend hold the template steady, and match it up several times. Be sure it works on both sides, if you are building exhaust on both sides, since each side of the bike is different.
Figure out how many welds you will need to make, if any, then purchase the tubes for your exhaust. Buy them to the full length of the system, which you should have measured using a flexible tape measure, or tailor's measure. Measure the outside edge of each side for the most accurate measurement and take the larger one and add a foot or so.
Mark the location of each bend with a magic marker at the start of the bend. Allow for an extra half foot at the head pipe section so you can fit the tube in the bender.
Heat and bend the pipe at each mark. Make your bends fast but be accurate and do not over bend the pipe. You don't want to have to bend the pipe backwards again.
Finish your bending, then attach the muffler. It should slide right on to your pipes.
Attach the hardware for the exhaust to your bike. This might have to be custom made as well. Then be sure the exhaust fits all the attachments, including the head pipes and rear braces.
Attach your new exhaust and pat yourself on the back. You made your own motorcycle exhaust.
Tips & Warnings
- A steel bender is the best way to bend your pipes. Heat your pipes until they bend very easily with out cuffing in.
- Avoid very sharp bends because when bending a tube it will buckle, and retard the flow of the exhaust.
How to Build Exhaust Headers
Adding exhaust headers may be the single easiest accessory you can add to improve engine performance. When working with modified cars and...
How to Make a Motorcycle Muffler Louder
Stock muffler pipes can be quiet and lackluster. However, an aftermarket motorcycle exhaust can cost $200 and up, which puts it out...
How to Build Custom Motorcycle Exhaust Systems
Motorcycles, as with most cars, generally come with a factory stock exhaust system. However, you may eventually decide you want to customize...
How to Make a Motorcycle Muffler Really Quiet
A quiet motorcycle muffler starts with the kind of engine that the motorcycle has. The quietest engines are small with a high...