How to Troubleshoot the Goodman Heater Gmp100 3

Save

The Goodman GMP1000-3 is a gas multi-flow heater for whole home use with a single-stage, induced draft motor. The furnace has an integrated control module with an aluminized steel heat exchanger and control panel with diagnostic features. Once the furnace is professionally installed, it should operate well when maintained on a regular basis and used correctly. However, even when operated normally, some problems may occur that require user troubleshooting.

Things You'll Need

  • Vacuum cleaner
  • Dishwashing liquid
  • Water
  • Make sure the main power switch to the Goodman furnace is “On” if the motor won’t start and the door switch is closed. Replace or reset the circuit breaker or fuse.

  • Remove the filter and clean with a vacuum cleaner or warm, soapy water and let dry, if the motor runs erratically or the blower flame is yellow and uneven. Disconnect the power to the furnace before performing maintenance.

  • Check the gas supply valve if the error light blinks once, which means ignition failure. Turn the gas supply valve to wide open.

  • Disconnect power and wait 30 seconds, then restore power if there are two error blinks, which mean the pressure switch has closed. Contact Goodman if the error light returns when the power is restored.

  • Turn down the thermostat and disconnect power if there are four blinks. Wait 30 minutes to restore power, as the open limit switch has tripped. Contact Goodman if the light continues to blink when the power is restored.

Tips & Warnings

  • Stop immediately if you smell gas. Disconnect power to the furnace and leave the house, then call the gas company.

Related Searches

References

Promoted By Zergnet

Comments

Resources

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!