How to Set Up Rooftop Christmas Decorations
Wait for a nice day to do this project. You don't want to be up on your roof wrestling reindeer in a snowstorm. Does this Spark an idea?
Other People Are Reading
Things You'll Need
- Christmas Displays
- Potassium Chloride-based Lawn Fertilizers
- Washing Machines
- Hot Cocoa
- 2-by-4 Boards
- Sandbags
- Saws
- Electric Screwdrivers
- Wood Screws
- Wood screws
Instructions
-
-
1
Decide where you want each piece of your display to stand. You may want to draw a sketch to take up on the roof with you.
-
2
Get some 2-by-4s ' scraps are fine. Cut them down to 18-inch lengths.
-
-
3
Determine the pitch of the roof. (See "How to Determine the Pitch of Your Roof," under Related eHows.)
-
4
Fasten one piece of wood vertically to the center back of a display by running a 2-inch wood screw from the front of the display to the back and into the board. The bottom of this display support should be even with the bottom of the display.
-
5
Repeat this every 24 inches or so on the back of every display. Too much is better than not enough.
-
6
Make an L shape with a second board, but not at a 90-degree angle. Instead, match the angle to the pitch of the roof so that when the display is on the roof, it will be standing straight up and down. The board should be wide-side down, not on its edge.
-
7
Run a 4-inch wood screw from the front of the display through the display support and into the bottom leg of the L.
-
8
Take the displays and a sandbag for every support up on the roof with you.
-
9
Set each display in place and hold it there with a sandbag over each lower support board.
-
1
Tips & Warnings
Use washers on the front of the display so that the screws don't pull through.
Make sure the roof isn't too icy to stand on. Sprinkle some potassium chloride-based fertilizer on the roof (or rock salt if there are no plants below) and let the ice melt a little.
Wear sensible shoes!
