Glass Handling & Safety

Save

Glass handling can involve certain hazards, especially when glass is installed during construction, requiring it to be transported and handled correctly. Specialists who work with glass installation are known as glaziers, and should always be trained to handle and store glass correctly. There are also several basic rules that should be followed when working with glass on construction sites and in factories.

Personal Protective Equipment (PPE)

  • When working with glass, it is important to wear the necessary protective gear to shield eyes and skin from injury if the glass breaks or shatters on impact. Eye gear is required when doing any sort of cutting or grinding, and is often recommended during installation procedures as well. Gloves and footwear that protect against cuts are also important when moving any type of glass pane.

Safe Lifting

  • Glass should not be unloaded on a sloping surface because its weight is distributed unevenly between the people unloading it. A smooth and level surface is best. Workers should also be very careful when lifting glass up ladders or installing it in windows. Weight should always be equally distributed throughout the pane of glass to avoid fractures.

Glass Storage

  • Glass should be stored in a specific type of base known as a 90 degree A-frame. These A-frames have 10 to 15 degree differences between the base and the level ground, but also have sloping back braces so that a 90 degree angle is formed, tilted slightly up to face away from the ground. This allows panes of glass to be placed in the frame with considerably less danger of them accidentally falling over.

Glass in Factories

  • The same basic safety protocols should be in place in factories where glass is used or frequently moved, including wearing protective gear. Glass should never be put on top of any type of machinery or work bench, where accidents are much more likely to occur and the vibration can break delicate types of glass. Glass light fixtures should be placed behind grates to protect them from accidents.

Cleaning Broken Glass

  • Broken glass should be guarded immediately by a sign warning of the accident so people avoid the area. Large particles should be removed by using a broom or brush, which should then be thoroughly cleaned and rinsed afterward. Smaller particles should be cleaned up with a disposable cloth or paper towel. The cloth will need to be thrown away afterward, since it will have caught up too many glass particles to be used again.

References

Promoted By Zergnet

Comments

You May Also Like

  • OSHA Standards for Blood & Body Fluid Cleanup

    Blood and bodily fluids have the potential to spread infectious diseases, like Hepatitis C, to workers who mishandle a spill. The U.S....

  • How to Transport Gas Cylinders

    Compressed gas cylinders, by definition, contain pressurized gas. These gases can be flammable or inert. However, due to the highly compressed state...

  • Safe Ways to Handle Fiberglass Insulation

    Fiberglass is made from glass and other fibers, with particles small enough to lodge in skin and lungs. It can be an...

  • Broken Glass Safety Policies

    Glass is fragile and subject to breakage. When glass breaks, the proper handling procedures, generally described in a safety policy, ensure the...

  • Ways to Handle Laboratory Apparatus

    Many dangers lurk in the laboratory. The most obvious risks are chemical hazards, but unsafe usage of laboratory apparati can lead to...

  • Handling Glass with Gloves

    With any stained glass project, learn how to protect your hands from being cut in this free video clip about using copper...

Related Searches

Check It Out

Are You Really Getting A Deal From Discount Stores?

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!