What Is Rim Backspacing?

Save

Wheel (or rim) backspacing is one of the ways that a wheel's dimensions and fitment applications are described; other measurements are offset, width, diameter and bolt pattern. A wheel's backspacing affects how it will fit on your car and is an important aspect of proper wheel fitment. Backspacing and offset are often confused.

Wheel Backspacing

  • Backspacing is the distance from the mounting pad of the wheel to the inside edge of the wheel. The mounting pad of the wheel is where the pad seats up against the hub.

Wheel Offset

  • Determining wheel offset uses a similar measurements used to determine backspacing but is the distance from the wheel pad to the center of the wheel.

How to Determine Backspacing

  • To determine a wheels backspacing, lay the wheel flat on the ground with the face of it facing down. Place a flat edge across the wheel so that it is supported on either side of the wheel. Using a tape measure or ruler, measure the distance from the pad in the center of the wheel (where the mounting holes are located) to the edge of the wheel. The distance is the backspace.

How Does it Affect Fitment?

  • Backspace affects fitment of a particular wheel on a particular vehicle because it affects how far out or in the wheel itself is located in relation to the hub. A wheel with a smaller backspace will locate the wheel away from the body and may result in fender rubbing while also increasing strain on the hub and suspension. A wheel with more backspacing has the opposite affect and moves the wheel in toward the body. This situation can result in the wheel interfering with and making contact with the brakes, suspension or inner wheel well.

Determining Offset

  • Knowing your wheel's backspacing is needed if you want to determine the wheel's offset. To determine offset, measure the wheel's width, which will end up being something like 6, 7 or 8 inches or more. Next, determine the wheel's centerline, which will be the measurement from the outside edge (or flange) to the inside edge divided by two. Subtract the wheel centerline from the backspace that was previously determined to get the offset. If the wheel's backspace is less than the wheel's centerline, then the wheel has a negative offset. If the backspace is larger than the wheel's centerline, then the wheel's offset is positive.

References

  • Photo Credit Image by Flickr.com, courtesy of Saquan Stimpson
Promoted By Zergnet

Comments

You May Also Like

  • What is Wheel Offset?

    Even for those who know quite a bit about cars there can be many unknown factors that affect a vehicle's performance. Most...

  • What Is a 0 Offset Wheel Backspace?

    If a car owner would like to exchange his stock wheels for an aftermarket type, there are many factors to consider. A...

  • How to Measure Car Rims

    The easiest measurement to consider when buying new rims for your vehicle is original equipment or stock rims. This would be the...

  • How to Measure Wheel Backspacing

    Measuring the backspace of your custom wheels can be critical in making sure that it will fit on your car or truck...

  • Wheel Backspacing Vs. Offset

    The terms backspacing and offset as applied to automotive wheels suggest the tire placement on the wheel relative to the centerline of...

  • Camaro 4th Gen Wheel Specs

    Fourth generation Camaros came in RS and, the more powerful, Z-28 trim lines. Some years also offered convertible versions of both. The...

Related Searches

Check It Out

How To Travel For Free With Reward Points

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!