Homemade Engine Hoist

Save

An engine hoist is a necessary piece of equipment for removing engines from all automobiles. Whether the vehicle is the family sedan, a sports car, truck, school bus, front, rear or mid engine, getting the engine out takes more than just muscle. Although in a pinch a child's playground swing set frame has been known to support an engine hoist, the materials used for these frames are too thin and light to support a heavy engine. Instead, build an engine hoist using 2-inch galvanized threaded pipe.

Design

  • Your engine hoist will have a square shape, with a crossbar over the top supported by two legs. The crossbar will have a winch and chain attached for connecting to and lifting the engine. Each leg will have wide arms at the bottom to provide greater stability. The engine hoist will be mounted on heavy casters so that after the hoist lifts the engine you can roll the engine away from the car to a workbench.

Construction

  • Use 2-inch threaded pipe to construct the crossbar of the hoist. One length of pipe wide enough to pass over a car's front fenders (7 feet is ideal) with two 90-degree elbow joints attached at each end. Connect 6-foot lengths of pipe to each elbow and at the other end attach cross connector fittings.

    Once the cross connector fitting are attached, add 3-foot pipe sections to the left and right. These will be "feet" for the engine hoist 6 feet across. Add 90-degree elbows at each end of the 3-foot pipes. Add one 3-inch pipe straight down from each cross connector fitting. Add a 3-inch pipe section to each elbow fitting on the feet. The engine hoist is now sitting on three 3-inch pipes on both sides.

Casters

  • Industrial supply houses stock large industrial casters with 2-inch threaded fittings. Buy six and and screw them on to each of the six 3-inch pipes. Now your engine hoist will roll straight and turn left and right. The total height to the crossbar is 6 feet plus 2 inches for each cross connector fitting and the 3 inches for the feet plus the casters. Total height of your engine hoist is between 7 and 7 1/2 feet.

Winch

  • Using chain, hang a ratchet winch from the crossbar and thread the ratchet with 2,500-pound-test link chain. Add a 1,000-pound-test hook on the chain. When the chain is lowered, the hook attached to the engine and the ratchet will lift the engine link by link.

References

  • Photo Credit hook and sky image by JoLin from Fotolia.com
Promoted By Zergnet

Comments

You May Also Like

  • How to Hoist an Engine

    Engines are the lifeblood of a vehicle, and sometimes they need to be removed. Be it for maintenance, replacement, or even just...

  • How to Lift an Engine

    The engine is the heart of your vehicle, and if it needs to be replaced, it can be a chore. But besides...

  • How to Remove a Car Engine Without a Hoist

    There are many parts which make up your vehicle, and for every part, it seems as if there are many different types...

  • Homemade Roofing Hoist

    Roofing contractors use manual and motorized hoists to load roofing materials. Hoist lines can be attached to a pallet for lifting bundles...

  • How to Make a Frame for a Hoist

    Hoists are powerful lifting devices capable of raising the engine of a car, for example. However, to actually function, a hoist needs...

  • Homemade Riding Lawn Mower Stand

    Buying a riding mower can be a good investment for your landscaping and yard maintenance chores. However, riding mowers require periodic service...

  • Homemade Jib Crane

    Jib cranes range in size from hundreds of pounds to tens of tons. They are known for long boom arms and swiveling...

Related Searches

Check It Out

How To Travel For Free With Reward Points

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!