Attaching Handle for Art Supplies Toolbox

Video Transcript

"Hi, this is Jon, and in this clip we will be attaching the handle. To attach the handle, we want to make it very secure, so when you lift up, it doesn't pull out. So what we're going to do is, we're going to put a couple of screws in each side, that are going to be an angle going downward into our handle. Additionally we are going to put a little bit of glue on it, just to give it that added holding power. First I'm just going to put a little bit of glue along the inside of the edges, and I'm going to slip my handle into place. Next I'm just going to be drilling a pilot hole, through my side into my handle. And after that I'm just going to install my screw. And another screw on the other side should do it. Now depending on the look you're going for, you can also countersink these screws, and even put a plug or a button on where that hole would be. And once you've installed that handle, you can go ahead and give it a test, make sure it doesn't shake around or it's not loose. "