How to Mix Mortar for Stone Pointing

Save

When old mortar begins to crack or crumble, while the bricks the mortar holds in place remain solid, replacing the mortar itself, instead of the entire wall is the typical remedy, known as stone pointing. You'll need to mix two batches of mortar to replace the single old mortar batch. The first batch serves as a filler mix, filling most of the joint between the mortar and adhering with existing undamaged mortar, which can differ greatly in content from modern mortar mixes. The second mix though is a more modern combination, a finishing mortar. This mix provides the flexibility needed to move along with the bricks, ensuring that it won't pull from the bricks after drying.

Things You'll Need

  • Large bucket
  • Sharp sand
  • Lime
  • Portland cement
  • Electric drill
  • Paddle bit attachment
  • Hawk
  • Tuckpointing trowel
  • Tamper
  • Plywood board
  • Shovel
  • Pour the mortar materials for the initial replacement layer into a large bucket. Combine seven parts sharp sand with one part lime and one part Portland cement as your dry mix.

  • Add water to the mix as you use an electric drill containing a paddle bit attachment to work the water evenly through the dry mix. Add the water slowly to the bucket until you have a mortar mix that's about the same consistency of peanut butter.

  • Scoop the mortar from the bucket to a hawk, then use a tuckpointing trowel to push the mortar from the hawk into the joints. Fill the joints between the stones for the first 1 1/2 to 2 inches in depth. Tamp the mortar into the joints tightly, compressing it to fill the space as completely as possible.

  • Mix the finish layer of mortar, to fill the last 1/2-inch layer of mortar in the joint, using a board instead of a bucket. Pour six parts sharp sand, one part lime and 3/4 part Portland cement into the middle of a large board. Add water to the mix and fold with a shovel until you have a mortar that's the same peanut butter like consistency as the first.

  • Scoop the finish mortar from the board to the hawk. Push the mortar from the hawk into the joints with the tuckpointing trowel, filling the rest of the opening between the stones to an even level.

Tips & Warnings

  • Wear work gloves, safety goggles and a respirator to avoid contact with mortar materials while mixing and applying the mixture.

References

  • Photo Credit Hemera Technologies/AbleStock.com/Getty Images
Promoted By Zergnet

Comments

Resources

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!