The carburetor on a Homelite trimmer helps deliver the fuel and air mixture to the internal combustion engine. After several seasons, gas and oil impurities will gradually deposit build up on the jets of the carburetor and in the walls of the cylinder. These deposits will choke the cylinder of air and fuel, which will lead to sluggish acceleration, poor idling and no power under load. To get the trimmer running well again, the carburetor must be removed, disassembled and cleaned.
Things You'll Need
- Socket wrench
- 3/8-inch socket
- Carburetor cleaner
- Compressed air
- Carb kit
Unhook the air filter housing cover. Take the air filter out of the box. Undo the two hex nuts with a socket wrench and 3/8-inch socket. Take the air filter-housing box off the carburetor’s two mounting studs.
Unplug the two gas lines from the carburetor’s elbow connectors using your fingers. Unscrew the two mounting screws holding the carburetor to the intake manifold. Pull the carburetor and gasket off the manifold.
Disassemble the carburetor carefully. Draw a diagram of all parts as you remove them to help with their reassembly. Unscrew all the outer screws holding the gaskets and diaphragms to the carburetor. Unscrew the needle valve retaining screw and remove the needle valve assembly from the carburetor. Undo the carburetor adjusting screws and remove them.
Soak all parts in a carburetor cleaner bath overnight. Scrub off all deposits still left with a brush. Blow out the two jets with compressed air. Don’t clean the diaphragms and gaskets if you don’t have a replacement carb kit with new diaphragms and gaskets.
Reassemble the parts in reverse order. Pay close attention to replacing the needle valve assembly. Insert the small spring into the hole. Place the needle valve with the valve lever on top of the spring. Replace any parts with the carburetor kit as needed. Reinstall the carburetor in the engine following the reverse of disassembly.
How to Adjust the Carburetor on a Homelite Chainsaw
The carburetors on Homelite chainsaws come with three adjustable settings that allow you to regulate fuel and engine speeds. While adjusting the...
How to Repair Homelite String Trimmers
When it comes to repairing a Homelite string trimmer it is always helpful to remember that they only need three simple things...
How to Adjust a Homelite Carburetor
The carburetor on a Homelite chainsaw controls the air-gas mixture that flows through the engine. Getting the precise balance between gas and...
How to Restring a Homelite Weed Wacker
Replacing the line on your Homelite weed whacker is a cost-effective way to keep your tool in top working condition. Rather than...
How to Adjust the Carburetor on a Homelite Weed Trimmer
The carburetor on a Homelite weed trimmer comes with adjustable screws that allow you to increase or decrease the fuel and oxygen...
How to Tune Up a Gas Trimmer
Tune up a gas trimmer by changing the spark plugs, making sure the wire fits snug to the top of the spark...
Troubleshoot a Homelite Weedeater
Homelite weed eaters are generally considered to be some of the most reasonably priced machines on the market. They are known to...