Fluorescent lights are often used in garages and basements where the tube is exposed in the fixture. While this allows for the full illumination that the fluorescent tube can offer, the light is harsh and unpleasant to the eyes, although it can be made softer and less harsh by covering it with a diffuser. The diffuser can be purchased precut for you from a hardware store. Household tools are needed to install the diffuser, but no electrical skills are necessary.
Things You'll Need
- Tape measure
- Plastic diffusion material
- Utility knife
- Power drill
- Metal screws
- Phillips screwdriver
- Fluorescent light fixture diffuser grille
- Drop ceiling diffuser panel
Fluorescent Light Fixture Diffuser
Place a ladder beneath the fluorescent light fixture. Turn the fluorescent light off. Let the fluorescent tube in the fixture cool for an hour before continuing.
Measure the length and width of the fixture, using a tape measure. Purchase a piece of plastic diffusion material that matches the measurements; if no piece matches the measurements, purchase a piece that comes close to matching and then cut the excess off using a utility knife.
Drill a hole one inch in from each end of the plastic diffusion material, using a power drill.
Hold the material against the light fixture, over the tube. Make a dot on the fixture through the two holes, using a pencil. Remove the material from the fixture.
Drill a hole in each of the dots with the power drill. Place the material back over the fixture. Screw metal screws through the material and into the fixture, using a Phillips screwdriver.
Move the ladder away. Turn the fluorescent light on to enjoy the diffused light now being emitted by the fluorescent light.
Fluorescent Diffuser Panel
Place a ladder beneath the drop ceiling that houses the fluorescent light fixture. Measure the length and width of the panel that is over the fixture, using a tape measure.
Purchase, at a hardware store, a drop-ceiling diffuser panel that matches the dimensions of the drop ceiling panel. If the size is unusual, have the hardware store cut a diffuser panel to size for you.
Lift up on one end of the drop ceiling panel that is over the fluorescent fixture. Slide the panel off the beam in the drop ceiling it is lying on. Slide the other side of the panel off the beam it is lying on. Place the panel away for safekeeping.
Slide one end of the diffuser panel on top of the beam on one side of the hole in the drop ceiling. Slide the other end of the diffuser panel on top of the beam at the other side of the hole.
Adjust the panel so that it is covering the hole. Move the ladder away. Turn on the fluorescent light to enjoy the diffused illumination.
Tips & Warnings
- The different patterns on the diffuser panel influence how much diffusion is created -- look through the panel before buying it to determine if it offers enough diffusion for your needs.
- How to Make a Photo Slide Viewer Light Box
How to Make Covers for Fluorescent Light Bulbs
Fluorescent lights can be set in ceiling fixtures to illuminate a room. These fixtures are typically covered with a plastic or acrylic...
Ways to Cover a Ceiling Light
Ceiling lights in your home can be an eyesore. Some homeowners cover these unwanted fixtures with large drum shades, while others simply...