How to Install Steel Cable Clamps

Save

Steel cable is a strong, flexible bundle of steel wires wound around a core of more steel strands. It is used on cranes and tow trucks to lift heavy weights, as support cables for utility poles and antennas, and even as the tight rope for high-wire acts in circuses. All these uses share a need to attach the steel cable to something else on one end or both. This is almost always accomplished by forming a loop in the cable and holding it tight with a cable clamp. The Occupational Health and Safety Administration approves only one method of securing a clamp.

Things You'll Need

  • Cable clamps
  • Thimbles
  • Socket wrench
  • Ratchet
  • Grasp the steel cable firmly and form a loop, leaving the recommended length of cable on the short side. For example, when using 1/2 inch cable the short side length is 11.5 inches.

  • Place the first cable clamp over both parts of the cable, locating it one width of the clamp base from the end of the short side of the cable. The U-bolt part of the clamp must be on the short cable side, and the base part of the clamp must be on the long side of the cable. Tighten the nuts securely.

  • Install the thimble in the loop and place another cable clamp as close to the thimble as possible. Again, the U-bolt part of the clamp must be installed over the short side and the base clamp must be on the long side of the cable. Tighten the nuts securely.

  • Install the remaining clamps equally spaced between the previous two clamps. Be certain to orient them the same way as the first two clamps. Tighten the nuts securely.

  • Check that all nuts are tightened properly. Apply a load to the cable. Release the load and tighten the clamping nuts again.

Tips & Warnings

  • Always wear leather gloves when working with steel cable.
  • OSHA requires a specified minimum number of cable clamps for each size of wire rope. To ensure your safety and avoid possible fines, determine how many clamps are required by OSHA.

References

  • Photo Credit Jupiterimages/Photos.com/Getty Images
Promoted By Zergnet

Comments

Resources

You May Also Like

  • How to Install Wire Rope Clamps

    Wire rope clamps are composed of a saddle, U-bolt and two hex nuts. This simple device makes a structurally strong connection when...

  • How to Fasten Cable Clamps

    Cable clamps are used to make a structural connection between two pieces of wire rope or to make a loop in a...

  • How to Install a Wire Rope Thimble

    Wire rope clips are used to put a thimble into the end of a wire rope. There are specific calculations that tell...

  • How to Install U-Bolt Cable Clamps

    U-bolt clamps can be used to join two metal cables together or to make a loop in a length of cable. The...

  • How to Attach a Fence to a Tree

    Improperly attaching a fence to a tree will result in a dead tree or a broken fence. As trees grow, the fences...

  • How to Tie Steel Wire Cable

    Steel wire rope was used to build some of the most famous bridges in the world, including the Brooklyn Bridge in 1855....

  • How to Clamp Steel Rope

    Whether you call it cable, wire rope, steel rope or steel wire rope, it is all the same thing. Steel rope is...

Related Searches

Check It Out

How To Travel For Free With Reward Points

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!