How to Wire an EZ Loader Trailer

Your EZ Loader trailer is subjected to regular dips in the lake that can corrode its electrical system. For this reason, it is wise to inspect its wiring system for cracked insulation or corroded terminals. When launching the boat, you should disconnect the trailer's wiring harness to avoid the chance of shorting a light bulb. Your EZ Loader uses a four-way trailer harness that provides power for signal, marker and brake lights. Replacing this harness is a simple process once you know where the wires go.

Things You'll Need

  • Trailer wiring harness
  • Cable ties
  • Waterproof electrical grease

Instructions

    • 1

      Remove the existing wiring harness from the trailer by cutting the cable ties that fasten it to the frame and pulling apart the connections at the lights.

    • 2

      Fasten the wiring harness's four-way connector to the trailer tongue with cable ties. Leave enough length to make it to the tow vehicle's connector, but not to much that the wires will drag on the ground.

    • 3

      Back off the grounding screw on the trailer's tongue and slide the white wire's ring terminal underneath. Tighten the screw back down. It is important that this connection be made to bare metal. Remove any corrosion with sand paper if necessary.

    • 4

      Run the brown wire on the harness to each marker light. Apply waterproof electrical grease to each connection and push together. The grease will prevent the trailer's electrical connections from corroding.

    • 5

      Run the yellow and green wire combo to the back left of the trailer and connect it to the left side light at the rear of the trailer.

    • 6

      Run the green and brown wire combo to the back right of the trailer and connect it to the right side light at the rear of the trailer.

    • 7

      Run the yellow wire to the left side of the trailer and connect it to the second light in from the left side of the rear of the trailer.

    • 8

      Run the green wire to the right side of the trailer and connect it to the second light in from the right side of the rear of the trailer.

    • 9

      Fasten all loose wires to the frame of the trailer with cable ties.

Related Searches

References

Resources

  • Photo Credit Logan Mock-Bunting/Getty Images News/Getty Images

You May Also Like

  • EZ Wiring Instructions

    EZ Wiring Instructions. ... How to Wire an EZ Loader Trailer. Your EZ Loader trailer is subjected to regular dips in the...

  • EZ Loader Trailer Specs

    EZ Loader manufactures boat trailers from roller trailers, bunk trailers to pontoon trailers. ... The wiring on a trailer is important to...

  • How to Wire Boat Trailer Lights

    How to Wire Boat Trailer Lights. ... Wiring diagrams and specifications; Resources. Read this Article in Spanish; Trailer Light Wiring; More Like...

  • How to Wire a Trailer

    Wiring a trailer is easy with instructions from a mechanic. ... How to Remount the License Plate Light Assembly on a Trailer....

  • How to Waterproof Trailer Wiring

    Install LED trailer lights. The wiring inside of these lights is fully protected. They are sealed units, waterproof, ... How to Wire...

  • How to Rewire Trailer Lights

    Over time problems with the wiring to the lights on trailers become increasingly common. Wires catch on sticks and twigs or get...

  • How to Wire Up Electric Trailer Brakes

    How to Install Trailer Brake Wiring on a Trailer; Comments You May Also Like. How to Wire Electric Trailer Brakes. Comments. You...

  • How to Wire a 5-Pin Flat Trailer Connector

    All the wiring on any 5-pin flat trailer connector follows an industry standard. Other People Are Reading. How to Wire a 5-Way...

Related Ads

View Photos

10 Fun Ways To Spend Your Tax Refund